The National Spherical Torus Experiment (NSTX) is being built at PPPL to test the fusion physics principles for the ST concept at the MA level. The NSTX nominal plasma parameters are R 0 = 85 cm, a = 67 cm, R/a ³ 1.26, B T = 3 kG, I p = 1 MA, q 95 = 14, elongation k £ 2.2, triangularity d £ 0.5, and plasma pulse length of up to 5 sec. The plasma heating / current drive (CD) tools are High Harmonic Fast Wave (HHFW) (6 MW, 5 sec), Neutral Beam Injection (NBI) (5 MW, 80 keV, 5 sec), and Coaxial Helicity Injection (CHI). Theoretical calculations predict that NSTX should provide exciting possibilities for exploring a number of important new physics regimes including very high plasma beta, naturally high plasma elongation, high bootstrap current fraction, absolute magnetic well, and high pressure driven sheared flow. In addition, the NSTX program plans to explore fully noninductive plasma start-up as well as a dispersive scrape-off layer for heat and particle flux handling. MotivationA broad range of encouraging advances has been made in the exploration of the Spherical Torus (ST) concept. 1 Such advances include promising experimental data from pioneering experiments, theoretical predictions, near-term fusion energy development projections such as the Volume Neutron Source 2 , and future applications such as power plant studies 3 . Recently, the START device has achieved a very high toroidal beta b T » 40% regime with b N » 5.0 at low q 95 » 3. 4 The National Spherical Torus Experiment (NSTX) is being built at PPPL to test the fusion physics principles for the ST concept at the MA level. 5 The NSTX device/plasma configuration allows the plasma shaping factor, I p q 95 / a B , to reach as high as 80 an order of magnitude greater than that achieved in conventional high aspect ratio tokamaks. The key physics objective of NSTX is to attain an advanced ST regime; i.e., simultaneous ultra high beta (b), high confinement, and high bootstrap current fraction (f bs ). 6 This regime is considered to be essential for the development of an economical ST power-plant because it minimizes the recirculating power and power plant core size. Other NSTX mission elements crucial for ST power plant development are the demonstration at the MA level of fully noninductive operation and the development of acceptable power and particle handling concepts. NSTX Facility Design Capability and Technology ChallengesThe NSTX facility is designed to achieve the NSTX mission with the following capabilities: ¥ I p = 1 MA for low collisionality at relevant densities, ¥ R/a ³ 1.26, including OH solenoid and coaxial helicity injection 7 (CHI) for startup,

After many years of fusion research, the conditions needed for a D–T fusion reactor have been approached on the Tokamak Fusion Test Reactor (TFTR) [Fusion Technol. 21, 1324 (1992)]. For the first time the unique phenomena present in a D–T plasma are now being studied in a laboratory plasma. The first magnetic fusion experiments to study plasmas using nearly equal concentrations of deuterium and tritium have been carried out on TFTR. At present the maximum fusion power of 10.7 MW, using 39.5 MW of neutral-beam heating, in a supershot discharge and 6.7 MW in a high-βp discharge following a current rampdown. The fusion power density in a core of the plasma is ≊2.8 MW m−3, exceeding that expected in the International Thermonuclear Experimental Reactor (ITER) [Plasma Physics and Controlled Nuclear Fusion Research (International Atomic Energy Agency, Vienna, 1991), Vol. 3, p. 239] at 1500 MW total fusion power. The energy confinement time, τE, is observed to increase in D–T, relative to D plasmas, by 20% and the ni(0) Ti(0) τE product by 55%. The improvement in thermal confinement is caused primarily by a decrease in ion heat conductivity in both supershot and limiter-H-mode discharges. Extensive lithium pellet injection increased the confinement time to 0.27 s and enabled higher current operation in both supershot and high-βp discharges. Ion cyclotron range of frequencies (ICRF) heating of a D–T plasma, using the second harmonic of tritium, has been demonstrated. First measurements of the confined alpha particles have been performed and found to be in good agreement with TRANSP [Nucl. Fusion 34, 1247 (1994)] simulations. Initial measurements of the alpha ash profile have been compared with simulations using particle transport coefficients from He gas puffing experiments. The loss of alpha particles to a detector at the bottom of the vessel is well described by the first-orbit loss mechanism. No loss due to alpha-particle-driven instabilities has yet been observed. D–T experiments on TFTR will continue to explore the assumptions of the ITER design and to examine some of the physics issues associated with an advanced tokamak reactor.

Wall conditioning in the Tokamak Fusion Test Reactor ͑TFTR͒ ͓K. M. McGuire et al., Phys. Plasmas 2, 2176 ͑1995͔͒ by injection of lithium pellets into the plasma has resulted in large improvements in deuterium-tritium fusion power production ͑up to 10.7 MW͒, the Lawson triple product ͑up to 10 21 m Ϫ3 s keV͒, and energy confinement time ͑up to 330 ms͒. The maximum plasma current for access to high-performance supershots has been increased from 1.9 to 2.7 MA, leading to stable operation at plasma stored energy values greater than 5 MJ. The amount of lithium on the limiter and the effectiveness of its action are maximized through ͑1͒ distributing the Li over the limiter surface by injection of four Li pellets into Ohmic plasmas of increasing major and minor radius, and ͑2͒ injection of four Li pellets into the Ohmic phase of supershot discharges before neutral-beam heating is begun.