Metode DC-Resistivity konfigurasi Wenner telah diaplikasikan pada situs cagar budaya Cot Sidi Abdullah (CSA) di Desa Kuta Krueng, Kecamatan Samudra Pasai, Kabupaten Aceh Utara. Data geolistrik diukur pada 8 lintasan sejajar dengan spasi lintasan 5 meter dari arah utara - selatan sepanjang situs dan spasi elektroda 0,5 meter. Berdasarkan hasil model penampang 2D diperoleh zona yang bersifat konduktif dengan kisaran nilai resistivitas 0,1 – 80 Ωm dan zona resistif dengan nilai reistivitas berkisar antara 100 – 600 Ωm dengan ketebalan lapisan 1 meter. Keberadaan zona yang relatif konduktif disebabkan oleh adanya intrusi air asin yang terdapat disekeliling daerah itu, yaitu area tambak dan sungai. Sedangkan zona resistif terdapat secara merata di semua lintasan yang umumnya berada di tengah–tengah lintasan dan dapat diprediksikan sebagai bagian dari situs yang tertimbun dibawah permukaan. Zona resistif berupa batu bata yang berada di sekeliling situs dan menahan intrusi air asin masuk ke tengah. Oleh karena itu bangunan Situs CSA diprediksi memiliki luasan sekitar 26 m x 35 m dengan bangunan sekeliling berupa batu bata dengan ketebalan dinding situs 1,5 meter. Sedangkan bagian tengah adalah timbunan pasir yang tidak dipengaruhi oleh air asin.Kata kunci: Metode geofisika, Arkeologi, Cot Sidi Abdullah, Metode DC - Resistivity, Resolusi Model, RekontruksiThe DC-Resistivity method with Wenner configurations was applied to the cultural heritages of Cot Sidi Abdullah (CSA) in Kuta Krueng Village, Samudra Pasai District, North Aceh Regency. Resistivity data were measured on 8 parallel lines with 5 meterline spacing from north to south of the sites and 0.5 meter electrode spacing. The 2D model results show that there are conductive region with the value of resistivity from 0.1-80 Ωm and resistive region with resistivity values ranging from 100 - 600 with a thickness of 1 meter. The existence of the relatively conductive region is caused by the sea water intrusions which is found surrounding the area, such as fish and river areas. However the resistive region is evenly found in all of the lines which are generally located in the middle of line and it was predicted as a part of Cot Sidi Abdullah site buried under the surface. The resistive region is consist of brick wall structures which surrounding the site can hold the sea water intrusions into the center of the sites. Therefore it can be concluded that the CSA Site has 26 m x 35 m areas which is surrounded by the brick structures with 1.5 meters thick. Howeverthe middle part of the site is filled with a sand material that is not affected by salt water.Key words: Geophysics Method, Archaeology, Cot Sidi Abdullah, DC- Resistivity Method, Model Resolution, Reconstruction

The need for clean water around the world is related to the increasing population, especially in Teupin Batee Village, Aceh Besar District. In addition to surface water, groundwater is one of the potentials that can be utilized by the community, particularly for household needs. The purpose of this study is to identify the aquifer layer using the geoelectric method. One of the geophysical methods that can be used to map groundwater potential is the geoelectrical method based on the resistivity value of subsurface rocks. This study uses the Wenner-Schlumberger array because it can map subsurface structures both vertically and horizontally. From the results of the study, it was found that there are four different layers in this research area including, the top soil layer, hard rock, tuffaceous sand and sand layer as aquifer layer. The top soil layer is mixed with tuff, sand and volcanic breccia to a depth of 8 m with a resistivity value of 5-25 ?m. The Hard rock layer is at a depth of 8 m – 30 m with a resistivity value of 45-220 ?m. The tuffaceous sand layer has a resistivity value ranging from 25-55 ?m. While the sand layer or aquifer is at a depth of 10 m – 60 m with a resistivity value of <10 ?m which is separated by a layer of tuffaceous sand between the two aquifer layers.