An innovative method for prestressing structural elements through the use of shape memory alloys (SMAs) is gaining increasing attention in research as this method does not require the use of mechanical anchorages for tendons. The activation of the memory effect by means of temperature variations (Joule effect) in effect produces high stresses in SMA components attached to concrete components as reported in the literature. This paper presents the work performed for the purpose of prestressing concrete hollow cylinders with the use of nickel–titanium (Ni–Ti) SMA wires. In the tests, a variety of hollow cylinders were made using the same concrete mix and with the same wall thickness (20 mm), but with different external diameters (200 mm, 250 mm, and 300 mm). Their prestressing was achieved by the means of Ni-Ti SMA wires of different diameters (1 mm, 2 mm, and 3 mm) wrapped around the cylinders. Longitudinal and circumferential strain during the thermal activation of the SMA wires by Joule heating was measured using gauges located on the internal surface of the hollow cylinders. The experimental protocol, recorded observations, and discussion of the effectiveness of the prestressing of concrete elements as a function of the test parameters are included in the text in detail. Comments on the conditions for effective prestressing of concrete cylinders with SMA wires are proposed in the conclusions of the paper.

The memory effect of shape-memory alloys (SMAs) has opened interesting perspectives to create prestress states in concrete elements. However, the procedure has not been yet fully resolved due to the complex thermomechanical behavior of these alloys, in addition to the practical difficulties of mechanical coupling between SMA and concrete elements. The present study deals with tests on the development of prestressing forces in concrete beams during the thermal cycle required in the procedure. Pre-stretched nickel–titanium wires were externally placed on concrete prismatic beams equipped with strain gauges. As concrete rupture may occur during the heating by the Joule effect, a compromise must be found between the SMA pre-stretch level and the maximum temperature to be applied before returning to ambient temperature. A macroscopic model was developed to analyze this compromise. The complex thermomechanical response of SMAs implies a particular attention in the definition of the ambient temperature and heating conditions for the creation of prestress states in concrete components.

International audienc