No abstract

One of the effective ways to solve the environmental problems of the region at present is the waste disposal from Novocherkasskaya TPP, one of the largest sources of environmental pollution. The solution to this problem is associated with the integrated use of ash and slag mixtures components in the effective building materials’ production. On the TPP waste basis, the authors obtained structural and heat-insulating concrete with enhanced physical, mechanical and operational characteristics.

No abstract

The results of selection and principles of calculating the ceramic masses composition for the clinker tiles’ production from argillites taking into account the raw materials’ characteristics are presented. The positive properties of argillites, as well as the properties that do not allow the tiles’ production of by stamping, which is traditional for these products’ manufacturing, are noted. Having low sensitivity to drying, low air shrinkage, high strength of the calcined shard, while being fusible sintering raw materials, argillites are low plastic and have insufficient bonding during molding, which indicates the need for corrective additives. In this work, the task to select the composition of ceramic masses to increase the plasticity of argillites while maintaining the positive properties of the main raw material was set. The authors proposed the use of siliceous clays as a corrective additive. An integrated approach was applied in calculating ceramic masses by grain composition and chemical and mineralogical indicators. Based on the research of A.I. Avgustinik, the oxide content Ca, Mg, Fe, Na, K and attitude Al2O3/SiO2 was taken into account. In order to obtain the densest packing, when calculating the grain composition, the natural dispersion of siliceous clays and the grain composition of previously prepared argillites were taken into account. The obtained theoretical calculations were tested in practice. Practical results showed that the 15% introduction of siliceous clay with the ceramic mass composition made it possible to obtain clinker tiles with improved physical and mechanical properties.