The possibility of using complex structure modification for aluminium casting alloys’ mechanical properties improvement was studied. The fluxes widely used in the industry are mainly intended for the modification of a single structural component of Al–Si alloys, which does not allow unifying of the modification process in a production environment. Thus, a new modifying flux that has a complex effect on the structure of Al–Si alloys has been developed. It consists of the following components: TiO2, containing a primary α-Al grain size modifier; BaF2 containing a eutectic silicon modifier; KF used to transform titanium and barium into the melt. The effect of the complex titanium dioxide-based modifier on the macro-, microstructure and the mechanical properties of industrial aluminium–silicon casting alloys containing 5%, 6%, 9%, 11% and 17% Si by weight was studied. It was found that the tensile strength (σB) of Al–Si alloys exceeds the similar characteristics for the alloys modified using the standard sodium-containing flux to 32%, and the relative elongation (δ) increases to 54%. The alloys’ mechanical properties improvement was shown to be the result of the flux component’s complex effect on the macro- and microstructure. The effect includes the simultaneous reduction in secondary dendritic arm spacing due to titanium, the refinement and decreasing size of silicon particles in the eutectic with barium and potassium, and the modifying of the primary silicon. The reliability of the studies was confirmed using up-to-date test systems, a significant amount of experimental data and the repeatability of the results for a large number of samples in the identical initial state.

Modification of the eutectic silicon in Al–Si alloys causes a structural transformation of the silicon phase from a needle-like to a fine fibrous morphology and is carried out extensively in the industry to improve mechanical properties of the alloys. The theories and mechanisms explaining the eutectic modification in Al–Si alloys are considered. We discuss the mechanism of eutectic rubidium modification in the light of experimental data obtained via quantitative X-ray spectral microanalysis and thermal analysis. X-ray mapping revealed that rubidium, which theoretically satisfies the adsorption mechanisms of silicon modification, had an effect on the silicon growth during solidification. Rubidium was distributed relatively homogeneously in the silicon phase. Microstructural studies have shown that rubidium effectively refines eutectic silicon, changing its morphology. Modification with rubidium extends the solidification range due to a decrease in the solidus temperature. The highest level of mechanical properties of the alloy under study was obtained with rubidium content in the range of 0.007–0.01%. We concluded that rubidium may be used as a modifier in Al-Si eutectic and pre-eutectic alloys. The duration of the modifying effect of rubidium in the Al-12wt%Si alloy melt and porosity in the alloy modified with rubidium were evaluated.