A simple, rapid, and efficient method, dispersive liquid-liquid microextraction (DLLME) coupled with high-performance liquid chromatography-fluorescence detector, has been developed for the determination of guaifenesin (GUA) enantiomers in human urine samples after an oral dose administration of its syrup formulation. Urine samples were collected during the time intervals 0-2, 2-4, and 4-6 h and concentration and ratio of two enantiomers was determined. The ratio of R-(-) to S-(+) enantiomer concentrations in urine showed an increase with time, with R/S ratios of 0.66 at 2 h and 2.23 at 6 h. For microextraction process, a mixture of extraction solvent (dichloromethane, 100 μL) and dispersive solvent (THF, 1 mL) was rapidly injected into 5.0 mL diluted urine sample for the formation of cloudy solution and extraction of enantiomers into the fine droplets of CH(2)Cl(2). After optimization of HPLC enantioselective conditions, some important parameters, such as the kind and volume of extraction and dispersive solvents, extraction time, temperature, pH, and salt effect were optimized for dispersive liquid-liquid microextraction process. Under the optimum extraction condition, the method yields a linear calibration curve in the concentration range from 10 to 2000 ng/mL for target analytes. LOD was 3.00 ng/mL for both of the enantiomers.

No abstract

No abstract

No abstract

A simple and sensitive method was developed for the analysis of preservatives sodium benzoate, methylparaben and propylparaben in nystatin suspensions by reversed-phase high performance liquid chromatography (HPLC), equipped with a C18 column and PDA detector. The mobile phase was a mixture of acetonitrile and acetate buffer of pH 4.4 (35:65 v/v). Under the optimized experimental conditions, separation of the preservatives was achieved in less than 20 min. The limits of quantifications (LOQs) and the linear dynamic ranges (LDRs) of sodium benzoate, methylparaben and propylparaben were 0.3 and 50-1000 μg ml -1 , 0.5 and 50-600 μg ml -1 and 0.3 and 50-900 μg ml -1 , respectively; the respective precisions (%RSD) at 500 μg ml -1 level were 0.72%, 0.73% and 0.51% (n = 6). The average recoveries of sodium benzoate, methylparaben and propylparaben for spiked nystatin samples were obtained as 98%, 97% and 98%, respectively.