Grit causes problems in water resource recovery facilities (WRRFs): clogging pipes, damaging pumps, and reducing the active volume of aeration tanks and anaerobic digesters by grit accumulation.Grit chambers are built to remove these particles. However, no standardized methodology exists to characterize grit particles for grit chamber design and operation despite the large observed variability in grit composition. Therefore, this paper proposes a combination and adaptation of existing methods to sample and characterize grit particles in view of proper grit chamber design and its modelling to ultimately optimize the efficiency of this important WRRF unit process. Characteristics evaluated included particle size distribution from sieving after different sample pretreatments, organic/inorganic fractions, and density.

Grit chambers are installed at the headworks of a water resource recovery facility (WRRF) to reduce the impact of grit particles to the equipment and processes downstream. This settling process should thus be designed and operated in an efficient way. Despite the importance of knowing settling characteristics for design and operation of grit chambers, previous grit definitions have been based only on particle size characteristics, and not on settling velocities. Thus, this study presents an evaluation of the performance of two promising settling velocity characterization methods, ViCAs and elutriation, to characterize wastewater particles in view of the design and the optimization of the efficiency of the grit removal unit. © 2019 Water Environment Federation • Practitioner points• Settling characteristics are the governing parameter for grit chamber design. Since grit particles are vastly heterogeneous, it is preferred to measure these characteristics directly rather than to estimate them from particle size (and assumptions of density, form factor, …). • More detailed settling information about grit particles can improve grit chamber design and estimation of removal performance. • Adapted ViCAs and elutriation methods for faster settling particles allow studying the particle settling characteristics in a grit chamber. These methods are simple, fast, and cheap and only require small wastewater samples. • A relationship was found between the influent TSS concentration and the location of the PSVD curve, with higher TSS concentrations corresponding to higher settling velocities. • It was demonstrated that the dynamics of the wastewater characteristics under dry, wet, and snowmelt weather conditions influence grit settling characteristics.

No abstract

No abstract