High-temperature corrosion in the superheater of a large-scale waste-to-energy plant was investigated. A comparison of nickel-/iron-based alloys and austenitic stainless steel probes placed in the furnace demonstrated that temperature and particle deposition greatly influence corrosion. Nickel-based alloys performed better than the other metal alloys, though an aluminide coating further increased their corrosion resistance. Sacrificial baffles provided additional room for deposit accumulation, resulting in vigorous deposit-induced corrosion. Computational modelling (FLUENT code) was used to simulate flow characteristics and heat transfer. This study has shown that the use of aluminide coatings is a promising technique for minimising superheater corrosion in such facilities.

No abstract

Large amounts of sludge are generated from wastewater treatment in seafood processing industries.Most of the dewatered sludge in Thailand is not utilized and disposed by land lling. The dried sludge utilization as refuse-derived fuel (RDF) is an alternative solution due to the gross calori c value (GCV), which is greater than 21.9 MJ/kg. However, the key obstacle is its high moisture content of 87.4% (wet basis). Therefore, drying methods using hot air and microwave techniques were investigated for preparing dried sludge. The effects of hot air temperatures (100-150 °C) and microwave power levels (100-800 W) were compared on drying kinetics, speci c energy consumption (SEC), and characteristics of the dried products. The results showed that drying times were decreased by increasing the hot air temperatures. In the same way, the increase in microwave power levels decreased the drying time. The application of microwaves contributed to reducing the drying time by more than 46% compared to the hot air. The reduction of drying times resulted in the saving SEC. The GCV of the dried sludge decreased with the decrease in the volatile matter (VM) due to the high component of VM as 79.5-80.3% (dry ash-free basis). The sludge dried by the microwaves showed a lower GCV than the hot air products. However, dried sludges still had high GCV (≥ 20.8 MJ/kg). Furthermore, the minimal variation of the product characteristics demonstrated that the microwave technique could be applied as an alternative drying method with a rapid process compared to the conventional hot air technique.