The fatigue crack growth behaviour of type 347 stainless steel in pressurized water reactor (PWR) conditions was investigated at two different temperatures, 25 and 316 °C. The fatigue crack growth rate was slightly increased at the elevated temperature in air. In the simulated PWR water environment, the fatigue crack growth rate was changed in a rather complicated manner with a change of the dissolved oxygen (DO) content. The DO content did not significantly change the fatigue crack growth rate at 25 °C. With the lower oxygen content of 5 ppb, which is the practical limit of deoxygenated water, the fatigue crack growth rate was similar at both 25 and 316 °C. The fatigue crack growth rate was significantly decreased at 316 °C with the higher oxygen level of 100 ppb. Under 316 °C water conditions, oxides were observed on the fatigue crack surface where the size of oxide particles was about 0.2 µm at 5 ppb and about 1 µm at 100 ppb. The thickness of the oxide layers also increased with the increase of DO. Moreover, the ΔK threshold (ΔKth) also increased as the DO increased from 5 to 100 ppb. The dissolved hydrogen levels did not affect the measured crack growth rate at the given test conditions. The decrease of the fatigue crack growth rate with higher DO content is attributed to a crack closure resulting from the formation of larger oxides near the crack tip at a rather fast loading frequency of 10 Hz that was used in this study.

No abstract