No abstract

No abstract

To improve RHIC luminosity for heavy ion beam energies below 10 GeV/nucleon, the Low Energy RHIC electron Cooler (LEReC) is currently under commissioning at BNL. The Linac of LEReC is designed to deliver a 1.6 MeV to 2.6 MeV electron beam, with rms dp/p less than 5e-4. A 704 MHz superconducting radio frequency (SRF) booster cavity in this Linac provides up to 2.2 MeV accelerating voltage. With such a low energy and very demanding energy spread requirement, control of Higher Order Modes (HOMs) in the cavities becomes critical and needs to be carefully evaluated to ensure minimum impact on the beam. In this paper, we report the multiphysics design of the HOM damper for this cavity to meet the energy spread requirement, as well as experimental results of the cavity with and without the HOM damper.DOI:

Two ac dipoles with vertical and horizontal magnetic field have been proposed at RHIC for applications in linear and non-linear beam dynamics and spin manipulations. A magnetic field amplitude of 380 Gm is required to produce a coherent oscillation of 5 times the rms beam size at the top energy. We take the ac dipole frequency to be 1.0% of the revolution frequency away from the betatron frequency. To achieve the strong magnetic field with minimum power loss, an air-core magnet with two seven turn winding of low loss Litz wire resonating at 64 kHz is designed. The system is also designed to allow one to connect the two magnet winding in series to resonate at 37 kHz for the spin manipulation. Measurements of a half length prototype magnet are also presented.

Abstmct-In this paper, we propose a simplified model for easy estimation of design parameters and quick analysis of inductive adder modulators. Analytical method is used to deduct the simplified circuit model. This model offers an easy way to understand the behavior of the inductive-adder modulator circuits and provides designers a helpful tool to estimate critical parameters such as pulse rise time, system impedance, number of adder stages, etc. Computer simulations demonstrate that parameter estimation based on simplified circuit model is fairly accurate as compared to original circuit. Further more, this approach can be used in early stage of system development to assist the feasibility study of the project and to aid geometry selection and parameter selection of critical components.