No abstract

No abstract

A high‐performance difunctional epoxy resin, 4‐(4‐hydroxyphenoxy)phenol diglycidyl ether (DHPOP), was synthesized by a two‐step method. The curing behavior of DHPOP was investigated by nonisothermal differential scanning calorimetry method and the curing kinetics results revealed that the introduction of ether linkage could improve the activity of epoxy groups, leading to a lower curing temperature and apparent activation energy compared with that of the commercial bisphenol‐A diglycidyl ether (DGEBA). A series of copolymers were then prepared by varying the mass ratio of DHPOP and DGEBA, which were cured with 4,4′‐diaminodiphenyl methane. The effect of DHPOP contents on thermal and mechanical properties and fracture morphology was studied. As expected, with the increase of DHPOP in the network, the impact strength and char yield were significantly enhanced, while the glass transition temperature (Tg) remained unchanged because of the increase of crosslink density. The excellent toughness endows the DHPOP with the promising potential for the application as high‐performance resin matrix. © 2018 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 46458.

Directionally solidified Al2O3/Er3Al5O12 (EAG) eutectic ceramic was prepared via vertical Bridgman method with high-frequency induction heating. The effects of the growth rate on the microstructure and mechanical properties of the solidified ceramic were investigated. The experimental results showed that there were no pores or amorphous phases in the directionally solidified Al2O3/EAG eutectic ceramic. Al2O3 phase was embedded in the EAG matrix phase, and the two phases were intertwined with each other to form a typical binary eutectic “hieroglyphic” structure. With the increase of growth rate, the phase size and spacing of the solidified Al2O3/EAG ceramic both decreased, and the growth rate and phase spacing satisfied the λ2v ≈ 60 formula of Jackson-Hunt theory. The cross section microstructure of the solidified ceramic always exhibited an irregular eutectic growth, while the longitudinal section microstructure presented a directional growth. The mechanical properties of the solidified ceramic gradually increased with the increase of growth rate, and the maximum hardness and fracture toughness could reach 21.57 GPa and 2.98 MPa·m1/2 respectively. It was considered that the crack deflection and branching could enhance the toughness of the solidified ceramic effectively.

No abstract