BackgroundBone tumors are often treated with intralesional curettage. High-speed burring, an adjuvant therapy, was performed to maximize the tumor cell killing; however, tumor recurrence might still occur, which may be caused by residual tumor or local tumor spread during surgery.MethodsA porcine cadaver (femur) was utilized to determine whether the use of a high-speed burr causes bone cement spray. To mimic residual tumor after curettage, luminescent cement was smeared on two locations of the bone cavity, the wall and the bottom. The cavity in the femoral bone was then placed in the middle of a sheet of drawing paper featuring 10 cm, 20 cm, and 30 cm concentric circles. The luminescent cement was then burred totally with a high-speed burr.ResultsThe intensity of the area in the wall in circle I was 72.6% ± 5.8%; within circle II, it was 22.1% ± 4.2%; and within circle III, it was 5.4% ± 1.5%. The intensity of the area within the bottom of the femoral bone within circle I was 66.5% ± 6.1%, within circle II was 28.1 ± 4.8%, and within circle III, it was 5.4% ± 1.4%. The amount of luminescent cement seeding decreased with distance, but there was no difference while burring at different locations of the bone cavity. Under the handpiece cover, a greater amount of cement spray was retained in circle I during burring of the cement in the bottom of the cavity and less was sprayed out in circle III.ConclusionsHigh-speed burring may cause tumor seeding, which could extend to 20 cm. The intensities of spray did not decrease, even when the handpiece cover was used. The correlation between high-speed burring and tumor seeding was highly suspect in this pilot study.

Background Bone tumors are often treated with intralesional curettage. High-speed burring, an adjuvant therapy, was performed to maximize the tumor cell killing; however, tumor recurrence might still occur, which may be caused by residual tumor or local tumor spread during surgery. Methods A porcine cadaver (femur) was utilized to determine whether the use of a high-speed burr causes bone cement spray. To mimic residual tumor after curettage, luminescent cement was smeared on two locations of the bone cavity, the wall and the bottom. The cavity in the femoral bone was then placed in the middle of a sheet of drawing paper featuring 10 cm, 20 cm, and 30 cm concentric circles. The luminescent cement was then burred totally with a high-speed burr. Results The intensity of the area in the wall in circle I was 72.6% ± 5.8%; within circle II, it was 22.1% ± 4.2%; and within circle III, it was 5.4% ± 1.5%. The intensity of the area within the bottom of the femoral bone within circle I was 66.5% ± 6.1%, within circle II was 28.1 ± 4.8%, and within circle III, it was 5.4% ± 1.4%. The amount of luminescent cement seeding decreased with distance, but there was no difference while burring at different locations of the bone cavity. Under the handpiece cover, a greater amount of cement spray was retained in circle I during burring of the cement in the bottom of the cavity and less was sprayed out in circle III. Conclusions High-speed burring may cause explosive bone cement spray, which could extend to 20 cm. The intensities of spray did not decrease, even when the handpiece cover was used. The wide range of bone cement spray caused by high-speed burr was inspected in this pilot study, which may lead to tumor seeding.