We have fabricated a Ti/ TiO 2 / Pt oxide diode with excellent rectifying characteristics by the asymmetric Schottky barriers at the Ti/ TiO 2 ͑0.13 eV͒ and the TiO 2 / Pt ͑0.73 eV͒ interfaces. Instead of homogeneous conduction, the current transport is governed by the localized oxygen-deficient TiO 2 filaments. In addition, the reproducible resistive-switching exists in the same structure, triggered by the forming process. The transition between two modes is ascribed to the destruction of the interface barriers at forming. The rectification stable up to 125°C and 10 3 cycles under Ϯ3 V sweep without interference with resistive-switching shows satisfactory reliability of TiO 2 diodes for one diode-one resistor memory devices.

This study revealed how the implant diameter and the three-dimensional (3D) BIC influence the primary stabilities of dental implant. ITV and PTV were more sensitively influenced by the implant diameter than ISQ. The pBICA and BICA seem to be more important than 3D BIC % for using wider implant in treatment plan, since those two parameters are highly predictive of variations in the primary stability of dental implant.

Digital periapical radiography is widely used in clinical dentistry because the technique is relatively simple and inexpensive. However, the main drawback of periapical radiography is that it represents a three-dimensional object in a two-dimensional film due to its inherent projection technique. The objective of this study was to develop a prototype intraoral computed tomosynthesis system, which can provide quasi-three-dimensional (so-called 2.5D) images. We developed a prototype intraoral computed tomosynthesis machine. Regular digital periapical radiography, computed tomosynthesis scanning, and computed tomography scanning of a human central incisor were performed. Then, reconstruction images obtained using computed tomosynthesis and computed tomography approaches were quantitatively evaluated using the signal-to-noise ratio (SNR) and contrast-to-noise ratio (CNR). From the experimental results, compared with periapical radiographic images, reconstruction images obtained using the computed tomosynthesis approach revealed detailed microstructures in different depth sections. In addition, the SNR and CNR of reconstruction images obtained using the computed tomography approach was better than those of the images obtained using the computed tomosynthesis approach. However, the differences could not be clearly identified by the naked eye. The preliminary experimental results indicate that an intraoral computed tomosynthesis system may be useful for clinical dental diagnosis.