In this study, we used tensiomyography (TMG) to assess muscle status immediately after an ultra-endurance triathlon. Maximal radial displacement or deformation of the muscle belly, contraction time, delay time, sustain time, and relaxation time were measured for both legs, and dependent t-tests were used to compare means between the beginning and end of the race. The 19 men assessed (age 37.9 ± 7.1 years; height 177.5 ± 4.6 cm; weight: 73.6 ± 6.5 kg) participated in the 2009 edition of the Lanzarote Ironman. Deterioration in the neural response was observed for contraction time (P = 0.008) and relaxation time (P = 0.011), with a moderate decrease in the response time (sustain time) and a loss in muscle stiffness (deformation of the muscle belly). The effect of muscle fatigue on the rectus femoris and biceps femoris was different. Barely any changes in contraction time, relaxation time, sustain time, and deformation of the muscle belly were observed, while only the contraction response time decreased to a significant extent (reduction in delay time; P = 0.003). The considerable loss in contractile capacity induced by a long-distance race was reflected in changes in the neuromuscular response and fluctuations in the contractile capacity of the muscle. These modifications, derived from a prolonged, exhausting effort, can be assessed in a simple, non-aggressive, non-invasive way using tensiomyography.

Martín-Rodríguez, S, Loturco, I, Hunter, AM, Rodríguez-Ruiz, D, and Munguia-Izquierdo, D. Reliability and measurement error of tensiomyography to assess mechanical muscle function: A systematic review. J Strength Cond Res 31(12): 3524-3536, 2017-Interest in studying mechanical skeletal muscle function through tensiomyography (TMG) has increased in recent years. This systematic review aimed to (a) report the reliability and measurement error of all TMG parameters (i.e., maximum radial displacement of the muscle belly [Dm], contraction time [Tc], delay time [Td], half-relaxation time [½ Tr], and sustained contraction time [Ts]) and (b) to provide critical reflection on how to perform accurate and appropriate measurements for informing clinicians, exercise professionals, and researchers. A comprehensive literature search was performed of the Pubmed, Scopus, Science Direct, and Cochrane databases up to July 2017. Eight studies were included in this systematic review. Meta-analysis could not be performed because of the low quality of the evidence of some studies evaluated. Overall, the review of the 9 studies involving 158 participants revealed high relative reliability (intraclass correlation coefficient [ICC]) for Dm (0.91-0.99); moderate-to-high ICC for Ts (0.80-0.96), Tc (0.70-0.98), and ½ Tr (0.77-0.93); and low-to-high ICC for Td (0.60-0.98), independently of the evaluated muscles. In addition, absolute reliability (coefficient of variation [CV]) was low for all TMG parameters except for ½ Tr (CV = >20%), whereas measurement error indexes were high for this parameter. In conclusion, this study indicates that 3 of the TMG parameters (Dm, Td, and Tc) are highly reliable, whereas ½ Tr demonstrate insufficient reliability, and thus should not be used in future studies.

No abstract

The purpose of the present study was to assess the ability of TMG in detecting mechanical fatigue induced by two different resistance exercises on biceps brachii: high-volume (HV), and high-load (HL). Sixteen healthy subjects (age 25.1±2.6years; body mass 79.9±8.9kg; height 179±7.4cm) performed arm-curl in two different protocols (HV: 8×15×10kg, HL: 5×3×30kg). Tensiomyography was used to assess muscle response to both exercise protocols. The contractile capacity of biceps brachii significantly varied by means of the effects of potentiation and fatigue mechanisms that take place at different exercise phases. The most significant changes correspond to values of maximum radial displacement of muscle belly (D(m)), sustained contraction time (T(s)), relaxation time (T(r)), and contraction velocity (V(c)). The behavior of these parameters is, in general, similar in both exercise protocols, but they show subtle differences among them. During the first set, in both protocols, values for V(c) increase, along with a decrease in T(r), T(s), and D(m) values. Fatigue onset was evident from changes in such parameters, with HL being the first in showing these mechanisms. Tensiomyography has been shown to be highly sensitive in detecting fatigue-induced changes.

This study analyzes the terminating actions (serve, attack, block and opponent error) resulting in point scoring for each team. These actions are then taken as reference indicators for observing the possibility of winning or losing a set in an elite men's volleyball competition. A total of 45 matches were studied at the European Men's Volleyball Championship held in September 2009 in Izmir and Istanbul (Turkey). Recordings were made of a number of game actions in a total of 168 sets. Analysis of these sets showed 132 ending in 25 points (78.57 percent) and 36 sets in more even matches (21.43 percent): 27 ending in more than 25 points (16.07 percent) and nine fifth or tie break sets (5.36 percent). Statistical analysis showed attacking to be the highest point-scoring technical action, but as matches became more even (sets with more than 25 points, or fifth and tie break sets), points scored by blocking became decisive for attaining victory in top-level competition. The number of errors made by each team is considerably lower at this level and points achieved through serving tend to be even.