Development of artificial tissues or organs is one of the actual tasks in regenerative medicine that requires observation and evaluation of intact volume microstructure of tissue engineering products at all stages of their formation, from native donor tissues and decellularized scaffolds to recipient cell migration in the matrix. Unfortunately in practice, methods of vital noninvasive imaging of volume microstructure in matrixes are absent. In this work, we propose a new approach based on high‐frequency acoustic microscopy for noninvasive evaluation and visualization of volume microstructure in tissue engineering products. The results present the ultrasound characterization of native rat diaphragms and lungs and their decellularized scaffolds. Verification of the method for visualization of tissue formation in the matrix volume was described in the model samples of diaphragm scaffolds with stepwise collagenization. Results demonstrate acoustic microscopic sensitivity to cell content concentration, variation in local density, and orientation of protein fibers in the volume, micron air inclusions, and other inhomogeneities of matrixes.

physica s s p status solidi b 1956 V. Levin et al.: The cluster architecture of carbon in polymer nanocomposites ß

No abstract

No abstract

The impulse acoustic microscopy method was applied to observe the bulk microstructure and to measure sonic velocities and elastic moduli in the carbon nanocomposite specimens prepared by a traditional method and with the use of a vacuum mixer. It is shown that carbon nanoparticles tend to cluster and form micron‐sized aggregates. The impulse acoustic microscopy technique makes it possible to visualize a non‐uniform distribution of carbon nanofillers over the specimen bulk. Both nanotube and nanoplatelets conglomerates are visible most likely due to the air containing. Results of the elastic measurements demonstrate homogeneity of elastic properties over the material bulk and a weak dependence of sonic velocities and elastic moduli on the filler content. Reduction of the air content and enhancement of elastic properties are observed when increasing the nanofiller content and employing the vacuum mixing technology in nanocomposite fabrication. POLYM. ENG. SCI., 57:697–702, 2017. © 2017 Society of Plastics Engineers