No abstract

Abstract. The aim of the present study was to compare preservation, staining and preparation techniques to assess the influence of different sample treatments and analyses on the accuracy of benthic foraminiferal assemblage data from NE Atlantic shelf seas. Replicate surface samples from the SE North Sea were preserved with ethanol–rose Bengal or formalin, some were stained after processing, or foraminifera were concentrated by flotation. Coloration of living specimens was different between samples treated with an ethanol–rose Bengal solution and those stained after washing. In the latter case, only the last two or three chambers were stained. The aliquot sample preserved with formalin showed dissolution features in agglutinated and porcellaneous species. Population density varied between different preservation, picking modes and investigators. The accuracy of picking was in the range of ±2 % (1σ), while external reproducibility ranged from −34 to +16 %. There was no significant difference between wet and dry picking. Samples that were concentrated by flotation generally yielded a lower number of specimens. Agglutinated species were under-represented in samples that were stained after washing and in the flotation concentrate. Size fractions showed a reduction of population density and Fisher alpha diversity index with increasing mesh size. Only half of the specimens and less than two-thirds of the species are captured if the >125 µm rather than >63 µm fraction is analysed. In oxygen minimum zones, where small-sized species dominate the assemblage, the recovery in larger size fractions could be lower.

No abstract

The article deals with the choice of cutterheads for Geokhod in the early development stages. Early development stages are characterized by the lack of quantitative characteristics, such as cutting forces, weight, feed forces, etc. In this case, the choice is made on the accordance of the cutterheads with the requirements for them. Under such conditions were determined the most appropriate method of multi-criteria analysis for the choice of the cutterheads – “ELECTRE III”. The results of the use of this method are established the most fully meet the requirements cutter heads: a rotary, drum, and head with fixed heads.

No abstract