No abstract

This study describes a modified approach for the detection of cardiac abnormalities and QRS complexes using machine learning and support vector machine (SVM) classifiers. The suggested technique overtakes prevailing approaches in terms of both sensitivity and specificity, with 0.45 percent detection error rate for cardiac irregularities. Moreover, the vector machine classifiers validated the proposed method's superiority by accurately categorising four ECG beat types: normal, LBBBs, RBBBs, and Paced beat. The technique had 96.67 percent accuracy in MLP-BP and 98.39 percent accuracy in support of vector machine classifiers. The results imply that the SVM classifier can play an important role in the analysis of cardiac abnormalities. Furthermore, the SVM classifier also categorises ECG beats using DWT characteristics collected from ECG signals.

No abstract

The selection of suitable composite material for high-strength industrial applications, from the list of available alternatives, is a tedious task as it requires an optimized structural performance-based solution. This study aimed to optimize the concentration of fillers, i.e., vinyl tri-ethoxy silane and absorbed gamma-dose, to enhance the properties of an industrial scale polymer, i.e., ultra-high molecular weight polyethylene (UHMWPE). The UHMWPE hybrids, in addition to silane, were treated with (30, 65, and 100 kGy) gamma dose and then tested for ten application-specific structural and performance attributes. The relative importance of attributes based on an 11-point fuzzy conversation was used for establishing the material assessment graph and corresponding adjacency matrix. Afterwards, the normalized values of attributes were used to establish the decision matrix for each alternative. The normalization was performed after the identification of high obligatory valued (HOV) and low obligatory valued (LOV) attributes. After this, suitability index values (SIVs) were calculated for ranking the hybrids that revealed hybrids 65 kGy irradiated the hybrid as the best choice and ranked as first among the existing alternatives. The major responsible factors were higher oxidation strength, a dense cross-linking network, and elongation at break. The values of the aforementioned factors for 65 kGy irradiated hybrids were 0.24, 91, and 360 MPa, respectively, as opposed to 0.54, 75, and 324 MPa for 100 kGy irradiated hybrids, thus placing the latter in second place regarding higher values of Yield Strength and Young Modulus. Finally, it is believed that the reported results and proposed model in this study will improve preoperative planning as far as considering these hybrids for high-strength industrial applications including total joint arthroplasty, textile-machinery pickers, dump trucks lining ships, and harbors bumpers and sliding, etc.

A Posidonia oceanica waste marine plant was used to produce a wet-laid nonwoven web for multifunction applications. To study the effect of some parameters related to the web characteristics (sheet weight, binder ratio, and pulp ratio) on the mechanical and physical properties of the web, we used a Box–Behnken design plan with three levels. The diagram of the superposed contours graphic method was used to find the optimum parameters of the process for the application of the Posidonia nonwoven fiber on an insulation field. With the measurement of the thermal conductivity properties using the box method, the results demonstrated that the nonwoven fiber from Posidonia oceanica marine waste had good insulation properties in comparison with other classical natural fibers (hemp, flax) used in the field of insulation with the big advantage of being a natural product.