Phylogenetic analysis of 166 human parvovirus B19 sequences from 11 different countries attributed 91.57% to genotype 1, 5.42% to genotype 3b, and 3.01% to genotype 3a. Very similar viruses of genotype 1 circulated widely in Europe and Israel. Genotype 3b seems to show an increasing spread outside of Africa.Human parvovirus B19 (B19V) infections are usually associated with mild disease, but in immunocompromised and anemic patients, as well as during pregnancy, severe complications can occur. Based on the genetic variability of 994 nucleotides (nt) of the NS1/VP1-unique region junction, three distinct genotypes of B19V have been proposed (13). A recent report presented evidence that certain complications might be preferentially associated with certain virus genotypes (6). Several studies demonstrated that previously published or commercially available assays show differences in their diagnostic performance, including the inability to detect certain genotypes, especially genotype 3, subtype 3b (1, 5). Despite these important implications for the diagnosis of B19V, little is known about the genotypes prevalent in many countries.Serum samples collected between 2000 and 2008 mostly from rash/fever patients negative for both measles and rubella from 11 different countries were analyzed for B19V (Table 1). A nested PCR was performed with the forward primers e1855f and e1863f (13) and reverse primers B19-R1 (5Ј-GGGAACT TCCGGCAAACTTCCTTG-3Ј) and B19-R2 (5Ј-GTAGTCTT TTACTACTTGTGCTTG-3Ј), yielding fragments of 1,239 and 1,168 nt. Previously published reverse primers (13) have a maximum of three (e2953r) and four (e2960r) mismatches compared to B19V GenBank sequences, including 3Ј and 5Ј

In this work, we developed a device capable to generate a non-thermal plasma discharge inside a sealed bag. The aim of this study was to assess the effectiveness of the oxygen, nitrogen and argon plasma sterilization on Pseudomonas aeruginosa, Staphylococcus aureus and Bacillus subtilis spores according to the NF EN 556 Norm. Moreover the bag integrity which is a critical key to maintain the sterile state of items after the end of the process was verified by Fourier Transform Infrared (FTIR) and X-ray Photoelectron Spectrometry (XPS) analyses. After plasma treatments, the bacterial counting showed a 6 log reduction of P. aeruginosa and S. aureus in 45 min and 120 min respectively whatever the gas used and a 4 log reduction of B. subtilis spores in 120 min with only oxygen plasma. These results were confirmed by Scanning Electron Microscopy (SEM) observations showing altered bacteria or spores and numerous debris. Taking into account the studied microorganisms, the oxygen plasma treatment showed the highest efficiency. FTIR and XPS analyses showed that this treatment induced no significant modification of the bags. To conclude this non-thermal plasma sterilization technique could be an opportunity to sterilize heat and chemical-sensitive medical devices and to preserve their sterile state after the end of the process.

In the healthcare environment, microorganisms’ cross-transmission between inanimate surfaces and patients or healthcare workers can lead to healthcare-associated infections. A recent interest has grown to create antimicrobial copper touch surfaces, in order to counteract microbial spread in the healthcare environment. For the first time, five French long-term care facilities were at 50% fitted with copper alloys door handles and handrails. Related to the environmental bacterial contamination, 1400 samples were carried out on copper and control surfaces over three years after copper installation. In addition, some copper door handles were taken from the different facilities, and their specific activity against methicillin-resistant S. aureus (MRSA) was tested in vitro. In comparison to control surfaces, copper door handles and handrails revealed significantly lower contamination levels. This difference was observed in the five long-term care facilities and it persists through the three years of the study. High and extreme levels of bacterial contamination were less frequent on copper surfaces. Although, the antibacterial activity of copper surfaces against MRSA was lowered after three years of regular use, it was still significant as compared to inert control surfaces. Therefore, copper containing surfaces are promising actors in the non-spreading of environmental bacterial contamination in healthcare facilities.

No abstract

To further investigate the genetic diversity of hepatitis B virus (HBV) genotype A in Africa, we analysed 263 HBV strains from Nigeria (n=163) and Cameroon (n=100). Phylogenetic analysis of S fragment sequences attributed 175 strains (66.5%) to genotype E and 88 (33.5%) to genotype A. In Cameroon, genotype A strains were the most prevalent (79/100, 79.0%), whereas, in Nigeria, genotype E was highly dominant (154/163, 94.5%). The genotype A strains grouped with reference strains of subgenotype A3 (n=8), the provisional subgenotype A5 (n=43), a recently reported new variant from Rwanda (n=35), or as outliers (n=2). Ten complete genome sequences obtained from strains that clustered with the new variant from Rwanda formed a separate group supported by a bootstrap value of 96. The between-group distance to other potential or recognized subgenotypes of genotype A was at least 3.81%. Thus, the new group of strains could be considered as a new subgenotype of HBV genotype A, tentatively named 'A7'. Interestingly, the 'A7' strains from Rwanda and Cameroon showed an interspersed clustering, but essentially no other (sub)genotypes were shared between the two countries, suggesting that 'A7' may have evolved in a yet unknown place and may have only relatively recently spread to Rwanda and Western Cameroon. Strains attributed to provisional subgenotype A5 were found for the first time in Cameroon (n=36) and Central Nigeria (n=2), indicating that A5 is more widespread than previously thought.