Abstract-The ankle joint of currently available powered prostheses is capable of controlling one degree of freedom (DOF), focusing on improved mobility in the sagittal plane. To increase agility, the requirements of turning in prosthesis design need to be considered. Ankle kinematics and kinetics were studied during sidestep cutting and straight walking. There were no significant differences between the ankle sagittal plane mechanics when comparing sidestep cutting and straight walking; however, significant differences were observed in ankle frontal plane mechanics. During straight walking, the inversion-eversion (IE) angles were smaller than with sidestep cutting. The ankle that initiated the sidestep cutting showed progressively increasing inversion from 2 to 13 degrees while the following contralateral step showed progressively decreasing inversion from 8 to 4 degrees during normal walking speed. The changes in IE kinematics were the most significant during sidestep cutting compared with straight walking. The IE moments of the step that initiated the sidestep cutting were always in eversion, acting as a braking moment opposing the inverting motion. This suggests that an ankle-foot prosthesis with active DOFs in the sagittal and frontal planes will increase the agility of gait for patients with limb loss.

No abstract

This article compares stochastic estimates of human ankle mechanical impedance when ankle muscles were fully relaxed and co-contracting antagonistically. We employed Anklebot, a rehabilitation robot for the ankle to provide torque perturbations. Surface electromyography (EMG) was used to monitor muscle activation levels and these EMG signals were displayed to subjects who attempted to maintain them constant. Time histories of ankle torques and angles in the lateral/medial (LM) directions were recorded. The results also compared with the ankle impedance in inversion-eversion (IE) and dorsiflexion-plantarflexion (DP). Linear time-invariant transfer functions between the measured torques and angles were estimated for the Anklebot alone and when a human subject wore it; the difference between these functions provided an estimate of ankle mechanical impedance. High coherence was observed over a frequency range up to 30 Hz. The main effect of muscle activation was to increase the magnitude of ankle mechanical impedance in all degrees of freedom of ankle.

This paper describes a novel cable-driven ankle-foot mechanism with two controllable degrees of freedom (DOF) in dorsiflexion-plantarflexion (DP) and inversion-eversion (IE). The presented mechanism is a proof of concept to demonstrate feasibility. Ankle kinematic measurements demonstrate that ankle IE rotations during a step turn are significantly different from walking on a straight path. This suggests that the ankle-foot mechanisms used in prostheses, exoskeletons, and bipedal robots can be improved by controlling a second degree of freedom in the frontal plane. The proposed prototype mechanism is described in detail, and its design considerations and parameters are presented. The mechanism is capable of producing trajectories similar to the human ankle during a step turn. The device shows passive mechanical impedance close to the human ankle mechanical impedance, allowing its mechanical impedance to be controlled using an impedance controller. The presented mechanism is capable of providing key mechanical characteristics similar to the human ankle, including power, range of motion, and weight, suggesting the feasibility of this design concept.

No abstract