A highly labor-efficient implementation of the Taylor dispersion method for measuring mutual diffusion coefficients in binary liquid systems is described. The experimental setup has been fully automated; it is possible to measure the diffusion coefficients over the whole concentration range in a single experiment using standard HPLC equipment. Software has been developed for processing the data; diffusion coefficients can be calculated from the measured concentration against time curve in various ways (e.g. from the first and second moments and by fitting procedures) within a few seconds. Experiments on the methanol + water system (25 and 35 "C) and the ethanol + water system (25 and 40 "C) have an accuracy of 0.5-1.5%. IntroductionLiquid diffusion plays an important role in chemical engineering, and the design of process equipment requires a knowledge of mutual diffusion coefficients. The purpose of this work is to develop an apparatus for measuring diffusion coefficients in liquid systems over a wide range of temperature and pressure in a fast, accurate, and laborefficient way. The instrument developed here should not need any repeated calibration, and the calculation of the diffusion coefficient from the measured variables is simple and easy to computerize.Experimental techniques used widely for measuring diffusion coefficients are the diaphragm cell technique, interferometric methods, and the Taylor dispersion method (1 -5). Interferometric methods permit the most accurate measurements near room temperature, but it is not (yet) possible to employ these instruments over a wide range of temperature and pressure. The disadvantages of the diaphragm cell are the necessity for calibration of the cell with a system of known diffusivity. Another disadvantage is the long measuring time. The Taylor dispersion technique provides a good alternative. The method is fast, the setup consists of standard HPLC components, and the measurements can be readily automated (6). Therefore, we have chosen the Taylor dispersion method.The Taylor dispersion method is based on the following principle (7, 8): a slow, laminar flow of a liquid mixture is pumped through a long capillary and a narrow pulse of a mixture of a slightly different composition is injected into this capillary. Due to the combined effects of convective flow and molecular diffusion, the pulse ultimately assumes a Gaussian distribution, whose temporal variance is dependent on both the average flow velocity and the molecular diffusivity.At the end of the diffusion capillary the concentration is measured as a function of time; the diffusion coefficient is calculated from the first and second temporal moments or by fitting the dispersion equation to the experimental curve.

No abstract

No abstract

No abstract

No abstract