We study the performance limits of mono-color cyclic coding applied to Brillouin optical time-domain analysis (BOTDA) sensors that use probe wave dithering. BOTDA analyzers with dithering of the probe use a dual-probe-sideband setup in which an optical frequency modulation of the probe waves along the fiber is introduced. This avoids non-local effects while keeping the Brillouin threshold at its highest level, thus preventing the spontaneous Brillouin scattering from generating noise in the deployed sensing fiber. In these conditions, it is possible to introduce an unprecedented high probe power into the sensing fiber, which leads to an enhancement of the signal-to-noise ratio (SNR) and consequently to a performance improvement of the analyzer. The addition of cyclic coding in these set-ups can further increase the SNR and accordingly enhance the performance. However, this unprecedented probe power levels that can be employed result in the appearance of detrimental effects in the measurement that had not previously been observed in other BOTDA set-ups. In this work, we analyze the distortion in the decoding process and the errors in the measurement that this distortion causes, due to three factors: the power difference of the successive pulses of a code sequence, the appearance of first-order non-local effects and the non-linear amplification of the probe wave that results when using mono-color cyclic coding of the pump pulses. We apply the results of this study to demonstrate the performance enhancement that can be achieved in a long-range dithered dual-probe BOTDA. A 164-km fiber-loop is measured with 1-m spatial resolution, obtaining 3-MHz Brillouin frequency shift measurement precision at the worst contrast location. To the best of our knowledge, this is the longest sensing distance achieved with a BOTDA sensor using mono-color cyclic coding.

No abstract

In this paper, we propose a novel Brillouin Optical Time Domain Analysis (BOTDA) set-up that combines simultaneous Brillouin gain/loss measurements with colour coding. This technique gives the advantage that the pump power can greatly be increased, compared to other coding schemes, thus increasing the sensing range. A first measurement over a 200 km fiber-loop is performed, with a 3 meter spatial resolution and an accuracy of  3 MHz (2) at the end of the sensing fiber. In a second set-up, high power flat pump pulses are generated by applying an arbitrary waveform signal on a frequency shifter, thus further increasing the performance of the novel Brillouin sensor. To the best of our knowledge, these are the best results obtained with a Brillouin sensor without Raman amplification.Index Terms-Brillouin scattering, fiber optics sensors, distributed fiber sensors, optical coding. 0733-8724 (c)

In this paper, we propose a novel coding for long range Brillouin Optical Time Analysis (BOTDA) distributed sensors based on a combination of time and frequency pulses, resulting in an additional coding gain of √2 with respect to traditional intensity-modulated codes. The generation of frequency-chirped pseudo-arbitrary pulses in return-to-zero (RZ) format with a Direct-Digital Synthesizer (DDS) is presented and the coding gain is experimentally verified, perfectly matching its theoretical value.

The possibility to customize Simplex coding for long range Brillouin Optical Time Domain Analysis is demonstrated by "colouring" the sequences in the frequency domain. The coding gain is identical to the traditional intensity-modulated Simplex code, though with much simplified series of sequences. The frequency-hopping pulses in return-to-zero intensity-modulated format are generated with a Direct-Digital Synthesizer. The proof-of-concept is experimentally demonstrated with measurements over a 50 km range (100 km fibre-loop) and a 2 meter spatial resolution.