No abstract

Addition of salts, especially perchlorates, to zwitterionic micelles of SB3-14, C(14)H(29)NMe(2)(+)(CH(2))(3)SO(3)(-), induces anionic character and uptake of H(3)O(+) by SB3-14 micelles. Thus, the addition of alkali metal perchlorates accelerates the acid hydrolysis of 2-(p-heptoxyphenyl)-1,3-dioxolane, HPD, in the presence of SB3-14 micelles, which depends on the local proton concentration at the micelle surface. The addition of metal chlorides to solutions of such perchlorate-modified SB3-14 micelles decreases both the negative zeta potential of the micelles and the observed rate constant for acid hydrolysis of HPD. The effect of the monovalent cations Li(+), Na(+), and K(+) is smaller than that of the divalent cations Be(2+), Mg(2+), and Ca(2+), and much smaller than that of the trivalent cations Al(3+), La(3+), and Er(3+). The major factor responsible for this cation valence dependence of these effects is shown to be electrostatic in nature, reflecting the strong dependence of the micellar surface potential on the cation valence. The fact that the salt effects are not identical after correction for the electrostatic effects indicates that additional secondary nonelectrostatic effects may contribute as well.

No abstract

This paper presents the physicochemical properties of micellar aggregates formed from a series of zwitterionic surfactants of the type 3-(1-alkyl-3-imidazolio)propane-sulfonate (ImS3-n), with n = 10, 12, 14, and 16. The ImS3-n dipolar ionic surfactants represent a versatile class of dipolar ionic compounds, which form normal and reverse micelles. Furthermore, they are able to stabilize nanoparticles in water and in organic media. Aqueous solubility is too low at room temperature to allow characterization of micellar aggregates but increases with addition of salts, allowing determination of aggregation number and cmc. As expected, these parameters depend on the length of the alkyl chain, and cmc values follow Klevens equation. In the presence of NaClO4, all ImS3-n micelles become anionoid by incorporating ClO4(-) on the micellar interface. A special feature of these surfactants is the ability to form reverse micelles and solubilize copious amounts of saline solutions in chloroform. (1)H NMR and infrared spectroscopic evidence showed that the maximum water to surfactant molar ratio w0 achievable depends on the concentration and type of salt dissolved. Reverse micelles of the ImS3-n surfactants can be used to stabilize metallic nanoparticles, whose size may be tuned by the amount of water dissolved.

A selective method is proposed for the determination of palladium, gold, and sulfur in catalytic systems, by direct liquid analysis using energy dispersive X-ray fluorescence (EDXRF), under an atmosphere of helium or air. This method allows a nondestructive analysis of palladium, rhodium, platinum, and gold nanoparticulate catalysts stabilized by imidazolium propane sulfonate based zwitterionic surfactants, allowing the samples to be reused for catalytic studies. The signals from palladium, rhodium, platinum, and gold samples in the presence of imidazolium propane sulfonate-based zwitterionic surfactants obtained using EDXRF before (Pd(2+), Rh(2+), Pt(2+), and Au(3+)) and after (Pd(0), Rh(0), Pt(0), and Au(0)) formation of nanoparticles are essentially identical. The results show that the EDXRF method is nondestructive and allows detection and quantification of the main components of platinum, gold, rhodium, and palladium NPs, including the surfactant concentration, with detection and quantification limits in the range of 0.4-3 mg L(-1). The matrices used in such samples present no problems, even allowing the detection and quantification of interfering elements.