Machined abutments retained a significantly greater percentage of torque compared with cast abutments. Casting procedures decrease the percentage of applied torque, which may influence final screw joint stability.

No abstract

The fracture strength of teeth with cast metallic posts, teeth with anatomical posts or teeth with glass fibre posts combined with accessory posts was similar. All teeth restored with cast metallic posts presented fractures and were unfavourable to maintenance of the remaining tooth structure. Teeth with fibre posts (Groups 2 to 5) presented variable fracture modes; however, the maximum percentage of unfavourable fractures was 30%.

AD children who have never eaten eggs may be sensitized and display reactions at the first ingestion. The percentage of reactions in this series was by no means negligible. These findings were observed in children with mild as well as moderate-severe AD when first examined. SPT for albumen and yolk diameter > or = 5 mm, and sIgE for albumen > 99 KU/L and for yolk > or = 17.5 KU/L were 100% specific in predicting the outcome of the challenge. It may thus be concluded that children with AD whose SPT and/or RAST for albumen and/or yolk are equal to or higher than these cut-off values should not be subjected to the oral challenge when consideration is given to the introduction of egg in their diet. Even when these cut-offs are not reached, however, clinical reactions to the challenge cannot be ruled out a priori, and it should be preferably performed in a protected environment, such as a hospital.

This study evaluated the effect of core-design modification on the characteristic strength and failure modes of glass-infiltrated alumina (In-Ceram) (ICA) compared with porcelain fused to metal (PFM). Premolar crowns of a standard design (PFMs and ICAs) or with a modified framework design (PFMm and ICAm) were fabricated, cemented on dies, and loaded until failure. The crowns were loaded at 0.5 mm min(-1) using a 6.25 mm tungsten-carbide ball at the central fossa. Fracture load values were recorded and fracture analysis of representative samples were evaluated using scanning electron microscopy. Probability Weibull curves with two-sided 90% confidence limits were calculated for each group and a contour plot of the characteristic strength was obtained. Design modification showed an increase in the characteristic strength of the PFMm and ICAm groups, with PFM groups showing higher characteristic strength than ICA groups. The PFMm group showed the highest characteristic strength among all groups. Fracture modes of PFMs and of PFMm frequently reached the core interface at the lingual cusp, whereas ICA exhibited bulk fracture through the alumina core. Core-design modification significantly improved the characteristic strength for PFM and for ICA. The PFM groups demonstrated higher characteristic strength than both ICA groups combined.