Abstract:This work presents an investigation to determine ground deformation based on an integration of DInSAR Time-Series (DTS) and Persistent Scatterer Interferometry (PSI) techniques aiming at detecting high rates of linear and non-linear ground movement. The combined techniques were applied in an open pit iron mine located in Carajás Mineral Province (Brazilian Amazon region), using a set of 33 TerraSAR-X-1 images acquired from March 2012 to April 2013 when, due to a different deformation behavior during the dry and wet seasons in the Amazon region, a non-linear deformation was detected. The DTS analysis was performed on a stack of multi-look unwrapped interferograms using an extension of the SVD (Singular Value Decomposition), where a set of additional weighted constraints on the acceleration of the displacement was incorporated to control the smoothness of the time-series solutions, whose objective was to correct the atmospheric phase artifacts. The height errors and the deformation history provided by the DTS technique were used as previous information to perform the PSI analysis. This procedure improved the capability of the PSI technique to detect non-linear movement as well as to increase the numbers of point density of the final results. The results of the combined techniques are presented and compared with total station/prisms and ground-based radar (GBR) measurements.
We present an investigation of surface deformation using Differential SAR Interferometry (DInSAR) time-series carried out in an active open pit iron mine, the N5W, located in the Carajás Mineral Province (Brazilian Amazon region), using 33 TerraSAR-X (TSX-1) scenes. This mine has presented a historical of instability and surface monitoring measurements over sectors of the mine (pit walls) have been done based on ground based radar. Two complementary approaches were used: the standard DInSAR configuration, as an early warning of the slope instability conditions, and the DInSAR timeseries analysis. In order to decrease the topographic phase error a high resolution DEM was generated based on a stereo GeoEye-1 pair. Despite the fact that a DinSAR contains atmospheric and topographic phase artifacts and noise, it was possible to detect deformation in some interferometric pairs, covering pit benches, road ramps and waste piles. The timeseries analysis was performed using the 31 interferometric pairs, which were selected based on the highest mean coherence of a stack of 107 interferograms, presenting less phase unwrapping errors. The time-series deformation was retrieved by the Least-Squares (LS) solution using an extension of the Singular Value Decomposition (SVD), with a set of additional weighted constrain on the acceleration deformation. The atmospheric phase artifacts were filtered in the space-time domain and the DEM height errors were estimated based on the normal baseline diversity. The DInSAR time-series investigation showed good results for monitoring surface displacement in the N5W mine located in a tropical rainforest environment, providing very useful information about the ground movement for alarm, planning and risk assessment.
ResumoOs sistemas de armazenagem industrial são, em geral, construídos em perfis formados a frio, com seções especialmente desenvolvidas para facilitar sua montagem, as seções "rack", que têm perfurações ao longo de sua altura para fixar as ligações. Essas particularidades induzem um comportamento diferenciado, em relação a outras seções. Devido à complexidade de sua análise, essas seções são, em geral, estudadas via métodos numéricos. O objetivo desse trabalho é o de desenvolver um modelo via elementos finitos para determinar a carga de flambagem e o modo de colapso de colunas formadas a frio perfuradas. Essa análise é feita, utilizando-se o software ANSYS, e a escolha do elemento, do refinamento da malha e da definição das condições de contorno é, cuidadosamente, determinada, a fim de garantir precisão ao modelo. A calibração do modelo é feita a partir da comparação com resultados da Teoria Generalizada de Vigas (GBT). Finalmente, os resultados numéricos são comparados com resultados experimentais. Essa comparação mostrou boa correlação, indicando que o modelo é adequado para a análise proposta.
Palavras
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.