Abstract. This study was focussed to investigate the effect of fluorocarbon, hydrocarbon and hybrid fluorocarbon on the mechanical properties and moisture regain of jute fiber reinforced composites. A significant difference in moisture regain values of treated and untreated reinforcement samples was observed at a concentration of 40 g/l. The composite made from treated reinforcement regained very low moisture content and exhibited improved mechanical properties (tensile and flexural strength). Being dual nature (hydrophilic and hydrophobic groups) of Hybrid fluorocarbon, the treated jute fibers and corresponding composites showed better properties as compared to other two chemicals due to better interface.

The aim of this study was to develop V-shape compression socks that should exert graduated lateral compression around the leg. For the development of socks, three types of yarns: main yarn (MY), plaiting yarn (PY) and inlaid yarn (IY) were used. Each yarn contained spandex yarn as the core. Machine adjustments were optimized to achieve the special V-shaped compression socks according to size of the wooden leg. Eighteen socks samples were developed and quantified for pressure exertion at ankle and calf portions using the MST MKIV, Salzmann pressure measuring device. Consequently, only two socks samples were accepted, which had the pressure exertion values of 21 mmHg and 23 mmHg with graduation percentage of 73% and 80%, respectively.

No abstract

No abstract

The purpose of this study was to examine the effect of spinning technologies and weave design on fabric mechanical and surface properties. For this purpose, ring spun (combed, carded) and open-end (OE) techniques were used to manufacture yarns of polyester cotton (50:50) which were used in the weft, and 100% cotton yarn in the warp. Plain, twill, and satin weave designs were selected to construct woven samples on a projectile loom. The variation in fabric tensile strength is obvious with respect to weave designs. Higher interlacing of yarn produces more crimp in the load bearing, which may cause lower breaking strength and fewer broad floats. The mechanical and surface properties of these fabric samples were investigated and statistical analysis was performed, which showed a significant effect of the spinning technique and weave design on these properties.