No abstract

The objectives of this study are to investigate the combined heat and mass transfer enhancement using binary nanofluids as a working fluid in a H 2 O/LiBr absorber. The result of heat and mass transfer experiment with the additives (arabicgum, 2E1H) showed that the heat and mass transfer performance of binary nanofluid with 2E1H enhanced significantly. In the case of 0.01 wt% Al 2 O 3 binary nanofluids with 2E1H, the vapor absorption rate increased up to 77% in comparison with that without the additives. The heat transfer rate of 0.01 wt% Al 2 O 3 binary nanofluids with 2E1H increased up to 19%. Based on the experimental results, it is recommended that the Al 2 O 3 binary nanofluid be good with 2E1H to improve the heat and mass transfer performance.

Articles you may be interested inHigh spatial resolution Hall sensor array for edge plasma magnetic field measurements Rev. Sci. Instrum. 76, 093501 (2005); 10.1063/1.2018628 Probes for high-frequency measurements in a plasma gun Rev. Sci. Instrum. 74, 1153 (2003); 10.1063/1.1533096 Small, high frequency probe for internal magnetic field measurements in high temperature plasmas Rev. Sci. Instrum. 72, 417 (2001);A rotating coil probe for the magnetic field measurement on a long pulsed tokamak Rev.The transient internal probe ͑TIP͒ is a diagnostic for local internal field measurements in high temperature plasmas. A verdet material, which rotates the polarization angle of the laser light under magnetic fields, is launched into a plasma at about 1.8 km/ s. A linearly polarized Ar + laser illuminates the probe in transit and the light retroreflected from the probe is analyzed to determine the local magnetic field profiles. The TIP has been used for magnetic field measurements on the helicity injected torus where electron temperature T e ഛ 80 eV. In order to apply the TIP in higher temperature plasmas, refractory clad probes have been developed utilizing a sapphire tube, rear disc, and a MgO window on the front. The high melting points of these refractory materials should allow probe operation at plasma electron temperatures up to T e ϳ 300 eV. A retroreflecting probe has also been developed using "catseye" optics. The front window is replaced with a plano-convex MgO lens, and the back surface of the probe is aluminized. This approach reduces spurious polarization effects and provides refractory cladding for the probe entrance face. In-flight measurements of a static magnetic field demonstrate the ability of the clad probes to withstand gun-launch acceleration, and provide high accuracy measurements of magnetic field.

No abstract