No abstract

Transparent heat films (THFs) are attracting increasing attention for their usefulness in various applications, such as vehicle windows, outdoor displays, and biosensors. In this study, the effects of induction power and radio frequency on the welding characteristics of silver nanowires (Ag NWs) and Ag NW-based THFs were investigated. The results showed that higher induction frequency and higher power increased the welding of the Ag NWs through the nano-welding at the junctions of the Ag NWs, which produced lower sheet resistance, and improved the adhesion of the Ag NWs. Using the inductive welding condition of 800 kHz and 6 kW for 60 s, 100 ohm/sq of Ag NW thin film with 95% transmittance at 550 nm after induction heating could be decreased to 56.13 ohm/sq, without decreasing the optical transmittance. In addition, induction welding of the Ag NW-based THFs improved haziness, increased bending resistance, enabled higher operating temperature at a given voltage, and improved stability.

No abstract

No abstract

>> The efficiency and life time of the Proton Exchange Membrane fuel cell (PEMFC) system is critically affected by incoming gas with humidity which should be maintained properly at normal operating conditions. Typically, incoming gas of automotive fuel cell is humidified by external humidifier but the characteristics of device is rarely reported. In this study, characteristics of water transfer in the membrane humidifiers have been experimentally investigated for flow rates of gas and for different flow arrangement under steady state condition. At first, capability of mass transfer through the membrane is examined at constant temperature. Then, the temperature distribution effect on the capability of mass transfer is tested over various inlet conditions. In summary, this research presents the mass transfer capability of hydrophilic membrane over various operating conditions.