The paper provides an overview of ways to increase the strength of polymer products obtained by fused filament fabrication (FFF) technology. An algorithm for calculating the spiral toolpaths for the material deposition using multi-axis printing is proposed. The design of the five-axis device for spiral-shaped deposition of the material is shown. The description of the proposed printing method is given. The results of comparative three-point bend and compression tests are presented. The standard samples obtained in the usual way by FFF technology, as well as samples with 2, 4, 6, 8 and 10 reinforcing layers obtained by spiral deposition of the material were investigated. The description of the tests is given, the dependences of the strength of the products on the number of reinforcing layers are obtained. Conclusions about the influence of the layer deposition method on the strength of the products are formulated.

No abstract

No abstract

No abstract

Methods of reinforcing products in additive manufacturing using continuous fibers was investigated in the paper, and also common problems inherent in 3D printing technologies including printing with continuous reinforcement was identified. The direction of development of the method of strengthening products with continuous fiber based on multi-axis printing of products with non-planar layers is proposed.