No abstract

The mechanical properties of two Zr-base bulk amorphous alloys (BAA), Zr-10Al-30Cu-5Ni (BAA-10) and , were studied by both tensile and compressive tests at room temperature in various test environments. The BAA ingots up to 7 mm in diameter were successfully produced by both arc melting and drop casting and induction melting and injection casting. The BAA specimens deformed mainly elastically, followed by catastrophic failure along shear bands. Examination of the fracture region revealed ductile fracture features resulting from a substantial increase in temperature, which was attributable to the conversion of the stored elastic strain energy to heat. Surprisingly, ''liquid droplets'' located at major shear-band cracks adjacent to the fracture section were observed, indicating the occurrence of local melting during fracture. The angle orientation of shear bands, shear-band cracks, and fracture surfaces relative to the stress axis is quite different for BAA specimens tested in tension and compression. This suggests that both shear stress and normal stress may play a role in developing shear bands during plastic deformation. The tensile properties of BAAs were found to be insensitive to the test environment at room temperature. However, the reaction of BAAs with distilled water and heavy water was detected by laser desorption mass spectrometry (LDMS). These results suggest that moisture-induced hydrogen embrittlement in BAAs may be masked by catastrophic fracture following shear bands.

No abstract

No abstract

No abstract