The presence of spherical solid particles immersed in an incompressible turbulent flow was numerically investigated from the perspective of the particle mass fraction (PMF or ϕm), a measure of the particle-to-fluid mass ratio. Although a number of different changes have been reported to be obtained by the presence of solid particles in incompressible turbulent flows, the present study reports the findings of varying ϕm in the the turbulent behaviour of the flow, including aspects such as: turbulent statistics, skin-friction coefficient, and the general dynamics of a particle-laden flow. For this purpose, a particle-laden turbulent channel flow transporting solid particles at three different friction Reynolds numbers, namely Reτ=180, 365, and 950, with a fixed particle volume fraction of ϕv=10−3, was employed as conceptual flow model and simulated using large eddy simulations. The value adopted for ϕv allowed the use of a two-way coupling approach between the particles and the flow or carrier phase. Three different values of ϕm were explored in this work ϕm≈1,2.96, and 12.4. Assessment of the effect of ϕm was performed by examining changes of mean velocity profiles, velocity fluctuation profiles, and a number of other relevant turbulence statistics. Our results show that attenuation of turbulence activity of the carrier phase is attained, and that such attenuation increases with ϕm at fixed Reynolds numbers and ϕv. For the smallest Reynolds number case considered, flows carrying particles with higher ϕm exhibited lower energy requirements to sustain constant fluid mass flow rate conditions. By examining the flow velocity field, as well as instantaneous velocity components contours, it is shown that the attenuation acts even on the largest scales of the flow dynamics, and not only at the smaller levels. These findings reinforce the concept of a selective stabilising effect induced by the solid particles, particularly enhanced by high values of ϕm, which could eventually be exploited for improvement of energetic efficiency of piping or equivalent particles transport systems.

No abstract

In the present study, through Computational Fluid Dynamics techniques, the performance characterization of a new Stairmand-type separator cyclone was carried out using the commercial software ANSYS Fluent. Four models for the geometrical cyclone separator were built, namely model A as per the dimensions reported in the literature and models B, C, and D by applying square and circular shape cavities as a passive flow control technique on the surface of its cylindrical section. The Navier-Stokes equations with the RSM turbulence model were formulated to solve the continuous phase of the cyclone separator and, the Lagrangian approach was adopted to track the solid particles with one way-coupling. The proposed model’s separation efficiency and pressure drop were compared against those recorded in the previous studies reported in the literature. Model D was the cyclone separator that stood out as the most valuable by demonstrating a separation efficiency and pressure drop decrement of 0.42% and 6.01%, respectively.

The constant advance in the development of piezoelectric materials for energy harvesting has demanded new implementations in the electronics field. The piezoelectric property of these materials has been considered an energy source for low-power devices; nevertheless, the units that provide energy are usually adapted to just one piezoelectric device. This aspect complicates the process, taking into account the amount of time needed for an energy harvest; therefore, this research inquired at first into the adequate piezoelectric materials for carrying out the current study. Afterwards, an energy management unit was designed, considering the connection between some modules and allowing the sourcing of an electrolytic cell for producing hydrogen and, in turn, energy. The results evidence a decrease in time charging of the energy storage unit, which allows a cell’s supply of energy in shorter time intervals, its design efficiency being about 90%, in such a way that the energy harvested through the piezoelectric devices can be used in a better manner.