No abstract

This paper presents two procedures for the determination of four selective serotonin reuptake inhibitors (citalopram, paroxetine, fluoxetine, and sertraline) and one metabolite (norfluoxetine) in sewage sludge utilizing three-phase hollow fiber liquid-phase microextraction (HF-LPME). First, direct HF-LPME was used for extraction, clean-up, and preconcentration. The pharmaceuticals were extracted from slurry samples into an organic phase and then back-extracted into an aqueous phase in the lumen of the hollow fiber. Second, a procedure combining pressurized hot water extraction and HF-LPME for clean-up and preconcentration was developed for the same analytes and matrix. The extracts were subsequently analyzed by liquid chromatography-mass spectrometry. For direct HF-LPME, limits of detection were between 1 and 12 ng g(-1) (dry weight) and the relative standard deviation (RSD) values were 3-12%. For the second method, limits of detection were approximately 6 ng g(-1) for all the compounds and RSD values were 8-12%. The methods were validated by comparison of results for the same samples. Sewage sludge from a Swedish wastewater treatment plant was analyzed by both methods; average concentrations were similar for citalopram, paroxetine, and fluoxetine with values of approximately 530, 40, and 200 ng g(-1) , respectively.

An automated method for analysis of unsaponifiable compounds in edible oils is presented. The method involves the on-line coupling of reversed-phase liquid chromatography and gas chromatography (LC-GC) using the through oven transfer adsorption desorption (TOTAD) interface. The oil is injected directly with no sample pretreatment step other than filtration. It may also be considered to dilute the oil sample. In the LC step, a short C4 column using a methanol/water eluent separates analytes from the other components of the oils, which are made up of mainly triglycerides. A LC fraction of up to 1.6 mL containing the analytes is transferred to GC at a flow rate of 0.1-2 mL/min. The TOTAD interface allows solvent venting and the introduction of the analytes into the GC column. The proposed fully automated method allows the analysis of different groups of compounds (free sterols, tocopherols, squalene, and erythrodiol and uvaol) in one chromatographic run or the analysis of these compounds in different groups. Sensitivity is more than necessary, and repeatability is good, the CV ranging from 3 to 12% for the full analysis.

No abstract

No abstract