No abstract

No abstract

A marine condenser with exhausted steam as the working fluid is researched in this paper. Constructal designs of the condenser are numerically conducted based on single and multi-objective optimizations, respectively. In the single objective optimization, there is an optimal dimensionless tube diameter leading to the minimum total pumping power required by the condenser. After constructal optimization, the total pumping power is decreased by 42.3%. In addition, with the increase in mass flow rate of the steam and heat transfer area and the decrease in total heat transfer rate, the minimum total pumping power required by the condenser decreases. In the multi-objective optimization, the Pareto optimal set of the entropy generation rate and total pumping power is gained. The optimal results gained by three decision methods in the Pareto optimal set and single objective optimizations are compared by the deviation index. The optimal construct gained by the TOPSIS decision method corresponding to the smallest deviation index is recommended in the optimal design of the condenser. These research ideas can also be used to design other heat transfer devices.