Lateral periodontal cyst (LPC) is an uncommon developmental odontogenic cyst arising on the lateral surface of tooth roots. Commonly reported in mandibular canine-premolar or maxillary anterior regions, it presents as a well-circumscribed or tear drop-shaped radiolucency with a sclerotic border. Associated teeth are asymptomatic and vital, and roots may be displaced without resorption. Histopathologically, cystic lining resembles reduced enamel epithelium along with glycogen-rich clear cells and epithelial plaques. Unilateral variant of LPC has low recurrence and is managed by enucleation. A 43-year-old male patient reported with asymptomatic swelling in the left mandibular canine and first premolar region. Both teeth were vital, and radiographs revealed well-circumscribed radiolucency between the roots. Following consent, surgical enucleation and guided bone regeneration (GBR) with xenograft and resorbable collagen membrane were done under local anesthesia. The immediate postoperative period was uneventful, and complete bone fill of cystic cavity and healing of periodontal tissues was observed after a one-year follow-up. Histopathologic examination confirmed the diagnosis. LPC should be a differential diagnosis in cystic lesions lateral to the surface of a tooth and without any associated inflammation. Based on this case report, unicystic LPC can be successfully managed through surgical enucleation with GBR for better periodontal healing.

Aim: To compare the color stability and degree of conversion (DC) of a resin cement containing a dibenzoyl germanium derivative photo-initiator (Variolink Esthetic) to resin cements containing conventional luting agents. Materials and Method: Spectrophotometry and Fourier transform infrared spectroscopy (FTIR) were used to compare the color stability and DC, respectively, of Variolink Esthetic compared to Calibra, Variolink-N, and NX3 resin cements. Ten specimens (1 × 2 mm2) of each resin cement were photo-polymerized and then subjected to color stability assessments. In addition, 30 samples of each of the four resin cements were prepared and then immersed in three staining solutions (tea, coffee, and distilled water) for two weeks. Changes in color for the immersed versus non-immersed specimens (control specimens) were determined by comparing ΔL (lightness), Δa, and Δb (color components), and an overall ΔE (color difference) obtained from spectrophotometry assays. One-way analysis of variance and a multiple comparison test (Tukey’s test) were used to analyze color stability and DC data. NX3 and Variolink Esthetic resin cements exhibited significantly lower values compared to the dual cured resin cements (Variolink-N and Calibra). Results: The highest DC values were observed among the photo-polymerized samples of Variolink Esthetic (87.18 ± 2.90%), while the lowest DC values were observed among the Variolink-N samples (44.55 ± 4.33%). Conclusion: The resin cement, Variolink Esthetic, containing a novel dibenzoyl germanium derivative photo-initiator exhibited superior color stability ( p < 0.05) and a higher DC than other resin cements containing conventional luting agents in an in vitro setting.