No abstract

The method of enamel conditioning revealed no significant effect on the enamel surface after debonding. Neither polishing via air abrasion nor carbide bur resulted in differences in superficial roughness. However, the carbide bur left a wave-like pattern on the enamel surface.

A wide array of elastic chains with various force levels is available. However, differences between products of greater than 100% were measured for force decay over time.

The highest shear forces were found for the conventional composites Transbond™ XT and Cool- Bond™ in combination with conventional etching. Air abrasion alone and in combination with phosphoric acid etching showed no advantages compared with phosphoric acid etching alone and, therefore, cannot be recommended.

The influence of the ligature or the active or passive self-ligating mechanism is minimal, and slot dimensions are far more important for the transmission of torque. The amount of torque exerted by the active spring clip is approximately 1/10th of the torquing moments recommended in the literature.