No abstract

The aim of the research work was focused on a research of manipulators design using suction grippers. The results of the research can be applied in the design of jigs - manipulators for handling thin sheets. The FME analysis was used in the investigation to show the course of elastic deformations and stresses in stressed areas. An experimental observation of the change in the free deflection of the workpiece from the positioning of the suction cups under gravity load by means of a laser 3D scanner was carried out for the FEM deflection detection method.

This paper presents the theoretical design for experimental verification of the structural and technological parameters of the Parallel Kinematic Structure. The experimental equipment was developed at the Faculty of Mechanical Engineering, STU in Bratislava. It is called Tricept, and due to its kinematics it is classified as a parallel structure. The previous phase of the project dealt with developing a mathematical model of the tool path. We have worked with two methods, a Monte Carlo method and the use of a mathematical analytical geometry structure. The calculated values were verified by comparing the results of the two methods. Based on the equations that were obtained, we can design the control of the tool path during cutting. The next stage focuses on the test methods and on verifying the structural and technological parameters of Tricept. The experiment is designed on the basis of the EN ISO 9283 standard, and involves testing the technological parameters: one-way positioning accuracy and repeatability of the position, changes of multidirectional positioning accuracy, repeatability and accuracy of the distance, position overshoot, drift of the position parameters, path accuracy, and repeatability of the path. This paper classifies the measurement methods and presents the measurement processes and the equipment for the experiment.

No abstract

No abstract