Inrushes of ground water and the ignition of flammable gases pose risks to workers in deep South African gold mines. Large volumes of water may be stored in solution cavities in dolomitic rocks that overlie the Black Reef (BLR) Formation, while there are several possible sources for methane, namely, coal seams, kerogen found in some gold ore bodies, or methane introduced by igneous intrusions. Potential conduits that may transport water and methane to underground workings were mapped using 3D reflection seismic data. Edge detection attributes successfully identified many faults, some with displacements as small as 10 m. Faults that displace the Ventersdorp Contact Reef (VCR) and the BLR horizons were of special interest, as known occurrences of fissure water and methane in underground workings show a good correlation with faults that were imaged on the VCR and BLR horizons. Because there are uncertainties in determining the linkage of faults with aquifers and methane sources, it is considered prudent to assume that all structures that displace the VCR and BLR horizons are potential conduits.

No abstract

No abstract

Seismic detection of faults, dykes, potholes and iron‐rich ultramafic pegmatitic bodies is of great importance to the platinum mining industry, as these structures affect safety and efficiency. The application of conventional seismic attributes (such as instantaneous amplitude, phase and frequency) in the hard‐rock environment is more challenging than in soft‐rock settings because the geology is often complex, reflections disrupted and the seismic energy strongly scattered. We have developed new seismic attributes that sharpen seismic reflections, enabling additional structural information to be extracted from hard‐rock seismic data. The symmetry attribute is based on the invariance of an object with respect to transformations such as rotation and reflection; it is independent of the trace reflection amplitude, and hence a better indicator of the lateral continuity of thin and weak reflections. The reflection‐continuity detector attribute is based on the Hilbert transform; it enhances the visibility of the peaks and troughs of the seismic traces, and hence the continuity of weak reflections. We demonstrate the effectiveness of these new seismic attributes by applying them to a legacy 3D seismic data set from the Bushveld Complex in South Africa. These seismic attributes show good detection of deep‐seated thin (∼1.5 m thick) platinum ore bodies and their associated complex geological structures (faults, dykes, potholes and iron‐rich ultramafic pegmatites). They provide a fast, cost‐effective and efficient interpretation tool that, when coupled with horizon‐based seismic attributes, can reveal structures not seen in conventional interpretations.

As expensive as 3D seismic reflection surveys are, their high cost is justified by improved imaging of certain ore horizons in some of the Witwatersrand basin gold mines. The merged historical 3D seismic reflection data acquired for Kloof and South Deep mines forms an integral part of their Ventersdorp Contact Reef mine planning and development programme. The recent advances in 3D seismic technology have motivated the reprocessing and reinterpretation of the old data sets using the latest algorithms, therefore significantly increasing the signal-to-noise ratio of the data. In particular, the prestack time migration technique has provided better stratigraphic and structural imaging in complex faulted areas, such as the Witwatersrand basin, relative to older poststack migration methods. Interpretation tools such as seismic attributes have been used to identify a number of subtle geologic structures that have direct impact on ore resource evaluation. Other improvements include more accurate mapping of the depths, dip, and strike of the key seismic horizons and auriferous reefs, yielding a better understanding of the interrelationship between fault activity and reef distribution, and the relative chronology of tectonic events. The 3D seismic data, when integrated with underground mapping and borehole data, provide better imaging and modeling of critical major fault systems and zones of reef loss. Many faults resolve as multifault segments that bound unmined blocks leading to the discovery and delineation of resources in faulted areas of the mines.