No abstract

No abstract

No abstract

No abstract

Two different methods of rapid manufacturing-electron beam additive manufacturing (EBAM) and laserengineered net shaping (LENS)-were used in order to fabricate NiTi elements. Microstructure and martensitic transformation temperatures of initial materials in the form of wire or spherical powder were established. The samples fabricated using LENS technique showed martensitic transformation temperature (MTT) at 2 26°C (represented by maximum martensite peak maximum in DSC) which was lower in comparison with raw powder. In the case of samples fabricated using EBAM, the MMT reached 2 19°C. The peaks of martensite and reverse transformations were diffuse due to differences in grain size and composition across the sample. Aging at 500°C for 2 h caused not only separation of R-phase during cooling of both samples, but also formation of sharper and higher transformation peaks as well as shift of MTT to higher temperatures. Microstructural investigation showed columnar grains, near the interface of deposited element and base plate, growing perpendicular to the plate surface. The grains showed axial fiber texture <001> along the growth direction. STEM micrographs revealed the presence of elongated particles enriched in Ti. Formation of Ti-rich particles during the process led to the depletion of Ti in the matrix and contributed to increase in MTT in comparison with initial NiTi powder. LENS-deposited sample additionally contained higher dislocation density in the austenite. Compression stress/strain curves of EBAM-deposited sample revealed deformation of martensite only, while the LENS-deposited one showed almost complete superelastic effect in compression mode up to 3%.