The electronic structure of a family of bis(imino)pyridine iron dihalide, monohalide, and neutral ligand compounds has been investigated by spectroscopic and computational methods. The metrical parameters combined with Mössbauer spectroscopic and magnetic data for ((i)PrPDI)FeCl(2) ((i)PrPDI = 2,6-(2,6-(i)Pr(2)C(6)H(3)N=CMe)(2)C(5)H(3)N) established a high-spin ferrous center ligated by a neutral bis(imino)pyridine ligand. Comparing these data to those for the single electron reduction product, ((i)PrPDI)FeCl, again demonstrated a high-spin ferrous ion, but in this case the S(Fe) = 2 metal center is antiferromagnetically coupled to a ligand-centered radical (S(L) = (1)/(2)), accounting for the experimentally observed S = (3)/(2) ground state. Continued reduction to ((i)PrPDI)FeL(n) (L = N(2), n = 1,2; CO, n = 2; 4-(N,N-dimethylamino)pyridine, n = 1) resulted in a doubly reduced bis(imino)pyridine diradical, preserving the ferrous ion. Both the computational and the experimental data for the N,N-(dimethylamino)pyridine compound demonstrate nearly isoenergetic singlet (S(L) = 0) and triplet (S(L) = 1) forms of the bis(imino)pyridine dianion. In both spin states, the iron is intermediate spin (S(Fe) = 1) ferrous. Experimentally, the compound has a spin singlet ground state (S = 0) due to antiferromagnetic coupling of iron and the ligand triplet state. Mixing of the singlet diradical excited state with the triplet ground state of the ligand via spin-orbit coupling results in temperature-independent paramagnetism and accounts for the large dispersion in (1)H NMR chemical shifts observed for the in-plane protons on the chelate. Overall, these studies establish that reduction of ((i)PrPDI)FeCl(2) with alkali metal or borohydride reagents results in sequential electron transfers to the conjugated pi-system of the ligand rather than to the metal center.

The bis(imino)pyridine iron bis(dinitrogen) complex, (iPrPDI)Fe(N2)2 (iPrPDI = 2,6-(2,6-iPr2C6H3NCR)2C5H3N), serves as an efficient precursor for the catalytic [2pi + 2pi] cycloaddition of alpha,omega-dienes to yield the corresponding bicycles. For amine substrates, the rate of catalytic turnover increases with the size of the nitrogen substituents, demonstrating competing heterocycle coordination and product inhibition. In one case, a bis(imino)pyridine iron azobicycloheptane product was characterized by X-ray diffraction. Preliminary mechanistic studies highlight the importance of the redox activity of the bis(imino)pyridine ligand to maintain the ferrous oxidation state throughout the catalytic cycle.

Using a sterically demanding amidinate ancillary ligand and an in situ alkylation procedure, neutral mono(amidinate) dialkyl and cationic mono(amidinate) monoalkyl complexes were prepared for metals spanning the full size range of the group 3 and lanthanide metals. The activity of the cationic monoalkyls in catalytic ethene polymerization was found to vary by over 2 orders of magnitude depending on the metal ionic radius, the intermediate metal sizes being found to be the most effective.

trans-(DMPE)2Ru(H)(NH2) (1) dehydrogenates cyclohexadiene and 9,10-dihydroanthracene to yield benzene (or anthracene), (DMPE)2Ru(H)2, and ammonia. Addition of fluorene to 1 results in the formation of the ion pair [trans-(DMPE)Complex 1 also reacts with weak acids A-H (A-H ) phenylacetylene, 1,2-propadiene, phenylacetonitrile, 4-(R,R,R-trifluoromethyl)-phenylacetonitrile, cyclobutanone, phenol, p-cresol, aniline) to form ammonia and trans-(DMPE)2Ru(H)(A) (7, 8, 9a, 9b, 10, 11b, 11c, 12, respectively). In the cases where A-H ) phenylacetylene, cyclobutanone, aniline, phenol, and p-cresol, the reaction was observed to proceed via ion pairs analogous to 4a. Compound 1 is reactive toward even weaker acids such as toluene, propylene, ammonia, cycloheptatriene, and dihydrogen, but in these cases deuterium labeling studies revealed that only H/D exchange between A-H and the ND2 group is observed, rather than detectable formation of ion pairs or displacement products. Addition of triphenylmethane to 1 results in the formation of an equilibrium mixture of 1, triphenylmethane, and the ruthenium/triphenylmethide ion pair 4h. If the energetics of ion-pair association are ignored, this result indicates that the basicity of 1 is similar to that of triphenylmethide. All these observations support the conclusion that the NH2 group in amido complex 1 is exceptionally basic and as a result prefers to abstract a proton rather than a hydrogen atom from a reactive C-H bond. The energetics and mechanism of these proton-transfer and -exchange reactions are analyzed with the help of DFT calculations.

Square planar iron methyl complexes containing bis(imino)pyridine (PDI) ligands have been prepared by reductive alkylation of the corresponding ferrous dichloride; dialkylation is observed upon treatment with a larger alkyl lithium.