No abstract

Electrical and thermal conductivity of composites which contain carbon-based fillers in an epoxy matrix were investigated. The fillers were dispersed in the liquid matrix by using three roll mill equipment. The filler/matrix mixture was cast in a mold and then cured, thus obtaining composite specimens. Multiwall carbon nanotubes, graphene-like nanoplatelets, and graphite were used as fillers and their effect on conductivity was investigated. Electrical and thermal conductivity were measured at different filler loads. It was found that the formation of percolation paths greatly enhanced electrical conductivity, although they were not so effective in improving thermal conductivity. The behavior of composites containing each single filler was compared with that of hybrid composites containing combinations of two different fillers. Results show that fillers with different aspect ratios displayed a synergetic effect resulting in a noticeable improvement of electrical conductivity. However, only a small effect on thermal conductivity was observed.

The orientation of reinforcing fibers in polymer‐based composites greatly affects their mechanical features. It is known that different orientations of continuous fibers in the stacked layers of a laminate play a crucial role in providing an isotropic mechanical behavior, while the alignment of chopped fibers in injection molding of composites results in a degree of anisotropy. Recent additive manufacturing techniques have offered a way of controlling the fiber orientation. This article aims to investigate the effect of fiber orientation on the mechanical properties of polyamide/carbon fiber composites processed by fused deposition modeling and selective laser sintering. Tensile samples which had different fibers and layer interface with respect to the sample axis (and therefore to the tensile load) were produced. Tensile tests were performed at different strain rates; the tensile properties and the fracture surface morphology were correlated with the processing method and the sample microstructure. The best strength and stiffness were observed when the fibers and the layer interfaces were parallel to the sample axis.

No abstract

The effect of carbon nanotubes, graphene-like platelets, and another carbonaceous fillers of natural origin on the electrical conductivity of polymeric materials was studied. With the aim of keeping the filler content and the material cost as low as possible, the effect of laser surface treatments on the conductivity of polymer composites with filler load below the percolation threshold was also investigated. These treatments allowed processing in situ conductive tracks on the surface of insulating polymer-based materials. The importance of the kinds of fillers and matrices, and of the laser process parameters was studied. Carbon nanotubes were also used to obtain piezoresistive composites. The electrical response of these materials to a mechanical load was investigated in view of their exploitation for the production of pressure sensors and switches based on the piezoresistive effect. It was found that the piezoresistive behavior of composites with very low filler concentration can be improved with proper laser treatments.