The article describes how to use vibration diagnostics to detect defects in the installation of new equipment and to determine the quality of repairs based on vibroacoustic characteristics. Especially relevant is the vibration diagnostics of rolling bearings before installation on the mechanism. If there are errors in the calculations of the magnetic system of synchronous generators, vibration occurs, which is not eliminated during operation. Design errors, poor assembly of pumping units, asynchronous motors, power transformers cause increased vibration, which leads to damage to the specified equipment. The main reasons causing the vibration of the transformer tank are considered and the frequency range from 50 to 6000 Hz is determined on which these defects can occur. Full-scale experiments of the vibration of the transformer tank have shown that certain defects can occur in a narrow frequency band. The practical application vibration diagnostics of the pump unit describes in this article. Technical diagnosis of pumping units of the sewer station was carried out for various included composition. The results obtained made it possible to exclude reverse hydraulic impacts as a possible cause of the failure of the pump unit.

The problem of increasing the reliability of detecting defects, both in new rolling bearings and the ones having already been in operation is current. The article describes the physical foundations of vibration of rolling bearings, caused by the different dimensions of the rolling elements and increased microwaves of the rings. A classification of rolling bearing defects was proposed, as well as calculation formulas for vibration frequencies corresponding to the indicated defects. It is shown that the vibration level at the overturning frequency depends on the gap size and the rotor mass. As an example, possible defects of rolling bearing No.310 were considered and their vibration frequencies were calculated. The frequency range in which defects of the rings and rolling elements appear was installed. An explanation of the reasons for the occurrence of high-frequency vibration was given. The combination of defects in the rolling elements of different dimensions and imbalance in the rotor causes the intensive development of microshells on the rolling bearing rings. Examples of experimental vibroacoustic characteristics were given to illustrate the physical processes of vibration in rolling bearings with various defects.