Abstract. The aim of the present study was to enhance the dissolution rate of meloxicam (MLX), a practically water-insoluble drug by preparation of solid dispersion using a hydrophilic polymer, poloxamer 188 (PXM). The kneading technique was used to prepare solid dispersions. A 3 2 full factorial design approach was used for optimization wherein the drug, polymer ratio (X 1 ), and the kneading time (X 2 ) were selected as independent variables and the dissolution efficiency at 60 min (%DE 60 ) and yield percent were selected as the dependent variable. Multiple linear regression analysis revealed that for obtaining higher dissolution of MLX from PXM solid dispersions, a high level of X 1 and a high level of X 2 were suitable. The use of a factorial design approach helped in optimization of the preparation and formulation of solid dispersion. The optimized formula was characterized by solubility studies, angle of repose, and contact angle; Fourier transform infrared spectroscopy, differential scanning calorimetry, x-ray diffraction studies, and scanning electron microscopy demonstrated that enhanced dissolution of MLX from solid dispersion might be due to a decrease in the crystallinity of MLX and PXM. Analysis of dissolution data of optimized formula indicated the best fitting with KorsemeyerPeppas model and the drug release kinetics as Fickian diffusion. In conclusion, dissolution enhancement of MLX was obtained by preparing its solid dispersion with PXM using kneading technique.

No abstract

Purpose: To investigate the effect of various surfactants and cosurfactants, and their ratio on microemulsions prepared with isopropyl palmitate (IPP)Methods: Tween 20, 40, 60, and 80 were used separately as surfactant with methanol, ethanol,

Nanoemulsions (NE) are isotropic, dispersions of oil, water, surfactant(s) and cosurfactant(s). A range of components (11 surfactants, nine cosurfactants, and five oils) were investigated as potential excipients for preparation of ketorolac tromethamine (KT) ocular nanoemulsion. Diol cosurfactants were investigated for the effect of their carbon chain length and dielectric constant (DEC), Log P, and HLB on saturation solubility of KT. Hen’s Egg Test—ChorioAllantoic Membrane (HET-CAM) assay was used to evaluate conjunctival irritation of selected excipients. Of the investigated surfactants, Tween 60 achieved the highest KT solubility (9.89 ± 0.17 mg/mL), followed by Cremophor RH 40 (9.00 ± 0.21 mg/mL); amongst cosurfactants of interest ethylene glycol yielded the highest KT solubility (36.84 ± 0.40 mg/mL), followed by propylene glycol (26.23 ± 0.82 mg/mL). The solubility of KT in cosurfactants was affected by four molecular descriptors: carbon chain length, DEC, log P and HLB. KT solubility was directly proportional to DEC and the HLB yet, inversely proportional to carbon chain length and log P. All surfactants, except Labrasol ALF, were non-irritant. The majority of cosurfactants were slightly irritant, butylene glycol was a moderate irritant, pentylene and hexylene glycols were strong irritants. These findings will inform experiments aimed at developing NE formulations for ocular administration of KT.

Abstract. Diazepam is one of the most prescribed benzodiazepines. The purpose of the present research was to optimize the formulation of orodispersible tablets of diazepam. Orodispersible tablets of diazepam were prepared using different types of superdisintegrants (Ac-Di-Sol, sodium starch glycolate, and crospovidone (CP)) and different types of subliming agents (camphor and ammonium bicarbonate (AB)) at different concentrations and two methods of tablets preparations (wet granulation and direct compression methods). The formulations were evaluated for flow properties, wetting time, hardness, friability, content uniformity, in vivo disintegration time (DT), release profiles, and buccal absorption tests. All formulations showed satisfactory mechanical strength except formula F5 which contains camphor and formula F9 which is prepared by direct compression method. The results revealed that the tablets containing CP as a superdisintegrant have good dissolution profile with shortest DT. The optimized formula F7 is prepared using 10% CP as a superdisintegrant and 20% AB as a subliming agent by wet granulation method which shows the shortest DT and good dissolution profile with acceptable stability. This study helps in revealing the effect of formulation processing variables on tablet properties. It can be concluded that the orodispersible tablets of diazepam with better biopharmaceutical properties than conventional tablets could be obtained using formula F7.