No abstract

No abstract

This paper presents a review of the properties of fresh concrete including workability, heat of hydration, setting time, bleeding, and reactivity by using mineral admixtures fly ash (FA), silica fume (SF), ground granulated blast furnace slag (GGBS), metakaolin (MK), and rice husk ash (RHA). Comparison of normal and high-strength concrete in which cement has been partially supplemented by mineral admixture has been considered. It has been concluded that mineral admixtures may be categorized into two groups: chemically active mineral admixtures and microfiller mineral admixtures. Chemically active mineral admixtures decrease workability and setting time of concrete but increase the heat of hydration and reactivity. On the other hand, microfiller mineral admixtures increase workability and setting time of concrete but decrease the heat of hydration and reactivity. In general, small particle size and higher specific surface area of mineral admixture are favourable to produce highly dense and impermeable concrete; however, they cause low workability and demand more water which may be offset by adding effective superplasticizer.

The construction industry of Malaysia is very dynamic in nature and the adoption of new technological advancements and construction methods has been a prime concerns for its key players and stakeholders. However, the adoption of BIM in such a dynamic industry is observed to be limited and its implementation has not been as successful as it should have been. The study focuses on the identification and prioritization the factors challenging the implementation of BIM in Malaysian construction industry. The data has been administrated through designed questionnaire by identifying the factors / barriers, by literature review, for implementation of BIM in construction industry. The prioritization of such factors is expected to help the major stake holders to address the issues according to their priority which will save lot of previous time and financial with smooth implementation of BIM in Architecture, Engineering and Construction (AEC) industry in future project.

No abstract