Introduction: Digital impression tools are an alternative to old impression materials and have developed significantly in recent years. These systems generally include two types of scanners: direct and indirect scanners. This article aimed to review and compare these two types of scanners. Description: Data were collected by reviewing a total of forty articles on dimensional accuracy, a combination of scans, and internal and marginal gaps for comparison of direct and indirect scanners. These articles were retrieved from PubMed and Scopus and published between 2010 and 2020 using the following keywords: intraoral scanner, lab scanner, marginal gap, internal gap, and accuracy rate. Results: Direct scanners had a lower amount of marginal and internal gaps, while indirect scanners had a lower deviation in more prepared teeth in the half and full arch due to the ability of stitching scans. Regarding the dimensional accuracy, the results of studies were inconsistent, but clinical studies pointed to the superiority of indirect scanners. The type of scanner suggested being selected depending on conditions such as the size of area, time, convenience of procedure, etc. The clinical results of both types of scanners were clinically acceptable.

Introduction. Porcelain-veneered zirconia (PVZ) restorations are increasingly used due to their optimal esthetics and high strength. However, chipping of porcelain limits the application of PVZ restorations. The aim of this study was to assess the shear bond strength (SBS) of colored and sandblasted zirconia to ceramic veneers fabricated by the pressing and layering techniques. Materials and Methods. Sixty cubic zirconia specimens (10 × 10 × 2 mm) were assigned to three groups according to their surface treatment: (I) control, (II) sandblasting with 50 μm alumina particles (S), and (III) coloring (C). Each group was subsequently divided into two subgroups according to the porcelain-veneering technique: (I) layering (L) and (II) pressing (P). The specimens underwent 10,000 thermal cycles between 5 and 55°C, and their biaxial SBS was measured in an electromechanical universal test machine (0.5 mm/min with 2.5 kN load cell). The failure mode was also assessed under a stereomicroscope. Three samples were randomly selected from each subgroup (n = 18) for examination of zirconia-phase transformation by X-ray diffraction (XRD). Two-way and one-way ANOVA followed by the post hoc Tukey test were used to analyze statistical differences among the groups and subgroups (α = 0.05). Results. The sandblasted zirconia with press porcelain (SP) subgroup showed the highest (24.40 ± 8.16 MPa) and the colored zirconia with press porcelain (CP) subgroup showed the lowest (13.76 ±3.62 MPa) SBS. All failures were cohesive. Rate of phase transformation in layered porcelain was significantly lower than that in pressed porcelain ( P < 0.01 ). Conclusion. The sandblasted group showed the highest and the colored group showed the lowest SBS; the layered group showed higher SBS than the pressed group.