Developing mature reservoirs is associated with challenges and limitations both in surface and subsurface. In This paper we will tackle the area of developing reservoirs with Maximum Reservoir Contact (MRC) wells by introducing our experience in combining it with LEL completion and introduce initial results in unlocking the potential of our reservoir with reduced capital expenditure (CAPEX). Conventional wells with 3000 ft open hole length become more challenging as development of the field progresses and especially with drilling new wells. Congestion and anti-collision at surface and subsurface limitations arise more often let alone the cost, manpower and environmental issues. We are going to introduce Maximum reservoir contact MRC wells with extended open hole length of around 10,000 ft. which allow to maximize gain from this well while optimizing other parameters (well spacing, cost…etc.). Measurement of rate and pressure, pre and post acid stimulation controlled by LEL completion as well as comparison with conventional water injectors in the vicinity were performed before to evaluate the performance of the MRC well. It was confirmed that MRC well injectivity surpasses the conventional injectors with shorter open hole length in relatively tight areas of the reservoir which have low permeability especially if equipped with LEL completion. Initial results show Injectivity improvement compared with nearby water injectors plus additional gain in injectivity noticed after acid stimulation with the LEL completion. The MRC well performance after stimulation showed well head injection pressure decreased drastically after the acid stimulation with increased injected volumes of water. This shows that smart completion solutions well help to improve performance and optimize acid stimulation which highlights the importance of combining MRC with LEL to maximize gain and enhance performance to take the maximum benefit. Through our success with MRC well with LEL completion the community of petroleum engineering will be able to take decisions regarding implementing this method and technology to optimize their drilling which will have positive impact in cost, planning and environment.