Portable biomimetic sensor devices for the express control of phenols content in water were developed. The synthetic binding sites mimicking active site of the enzyme tyrosinase were formed in the structure of free-standing molecularly imprinted polymer membranes. Molecularly imprinted polymer membranes with the catalytic activity were obtained by co-polymerization of the complex Cu(II)-catechol-urocanic acid ethyl ester with (tri)ethyleneglycoldimethacrylate, and oligourethaneacrylate. Addition of the elastic component oligourethaneacrylate provided formation of the highly cross-linked polymer with the catalytic activity in a form of thin, flexible, and mechanically stable membrane. High accessibility of the artificial catalytic sites for the interaction with the analyzed phenol molecules was achieved due to addition of linear polymer (polyethyleneglycol Mw 20,000) to the initial monomer mixture before the polymerization. As a result, typical semi-interpenetrating polymer networks (semi-IPNs) were formed. The cross-linked component of the semi-IPN was represented by the highly cross-linked catalytic molecularly imprinted polymer, while the linear one was represented by polyethyleneglycol Mw 20,000. Extraction of the linear polymer from the fully formed semi-IPN resulted in formation of large pores in the membranes' structure. Concentration of phenols in the analyzed samples was detected using universal portable device oxymeter with the oxygen electrode in a close contact with the catalytic molecularly imprinted polymer membrane as a transducer. The detection limit of phenols detection using the developed sensor system based on polymers-biomimics with the optimized composition comprised 0.063 mM, while the linear range of the sensor comprised 0.063-1 mM. The working characteristics of the portable sensor devices were investigated. Storage stability of sensor systems at room temperature comprised 12 months (87%). As compared to traditional methods of phenols detection the developed sensor system is characterized by simplicity of operation, compactness, and low cost.

No abstract

No abstract

No abstract

The preparation of filled two‐component semi‐interpenetrating polymer networks (semi‐IPNs) is described and the results of an investigation of their morphology by means of dynamic mechanical spectroscopy are considered. The influence of an active dispersed filler (γ‐Fe2O3) on the semi‐IPNs phase structure is studied. A comparison is made between filled and unfilled semi‐IPNs consisting of compatible or incompatible polymers. In the case of a semi‐IPN of compatible polymers, the introduction of γ‐Fe2O3 was observed to cause phase separation. With a two‐phase semi‐IPN the introduction of the filler enhanced the phase separation. The presence of two distinct peaks (the dynamic glass transition temperatures) corresponding to those of the two initial homopolymers shows the semi‐IPN to have a two‐phase structure.