A simple wear test was investigated for evaluating the wear and damage of material pairs when used in total knee replacement. The test consisted of an axially loaded metallic femoral indentor and a reciprocating ultrahigh molecular weight polyethylene (UHMWPE) flat disk that represented the tibial component. A number of variables were studied including the effect of conformity by varying the radii of the femoral surface, distilled water or serum as a lubricant, different femoral materials, and different types of UHMWPE. In general, the different morphologies of the surface wear of the UHMWPE were similar to those seen on retrieved total knee replacements. Increased conformity with a cylindrical indentor gave a reduced wear rate initially, compared with that of the lower conformity spherical indentor. However, the wear rates were similar subsequent to this initial wearing in phase. Transfer films of UHMWPE were observed on the cobalt-chrome indentors for both serum and distilled water lubrication, although this film was more extensive for distilled water. The lowest wear rate was observed when oxidized zirconium was used on the femoral side, which was attributed to greater wettability, surface hardness, and immunity to oxidative wear. Tests using cobalt-chrome femoral cylinders and different grades of UHMWPE showed different wear rates. Of these PEs, GUR 415 showed less wear than both RCH 1000 and UHMWPE containing numerous fusion defects. For the latter, wear was attributed to a fatigue mechanism, although in most cases it was associated with surface phenomena rather than subsurface cracking. However, in some specimens of UHMWPE subsurface crack propagations occurred with defects. The test method is discussed in relation to its applicability to the evaluation and comparison of bearing materials and surfaces, with particular application to total knee replacements.

No abstract

No abstract