No abstract

No abstract

Time signals recorded by the on-board diagnostic system (OBD), describing the manner of vehicle’s movement in actual road conditions show non-stationarity and non-linearity, as well as statistical multiscalarity. In practice, it means that the analysis of registered time series requires modelling of non-linear phenomena. The aim of this study was to examine the nature of the vehicle speed profile in actual road conditions with the method of multifractal analysis. A number of studies indicates that the driving tests applied for many years have not been representative for the actual operating conditions of vehicles. For both the new Worldwide Harmonised Light duty Test Cycle (WLTC), a worldwide harmonised procedure of light vehicle testing, as well as in actual urban driving conditions along the measuring route, being subject to empirical research, confirmation of strong multifractal properties of the recorded vehicle speed time series have been obtained.

The article presents the possibility of verifying the efficiency of a diesel particulate filter (DPF) with the use of particle counters using two different measurement methods. The tests were carried out at a vehicle inspection station using a condensation particle counter (CPC) and a diffusion charger (DC). This article presents the results of measurements of 50 vehicles. Removal of the diesel particulate filter from a vehicle is prohibited but is a known phenomenon throughout the EU. The task of periodic technical inspections is to eliminate vehicles that are inoperative and do not meet the environmental protection requirements. However, to date, European vehicle inspection stations do not have an effective tool to counter tampering with diesel particulate filters. The performed measurements allowed us to prove the hypothesis that both methods of measurement allow the effective confirmation of the presence of DPF in a vehicle during the periodic technical inspection of the vehicle and verification of the quality of its operation. In addition, the advantages and disadvantages of both measurement methods were assessed.

The electric car market is becoming more and more extensive. According to ACEA, in 2019, 549,387 full electric passenger vehicles, hybrid plug-ins and hydrogen vehicles were registered in the European Union. Thus, it is an increase of 52.9 percent compared to 2018. Germany is the leader with 108 839 registrations of vehicles (+60.9% y/y). Great Britain achieved an increase of 21.5 percent y/y and the number of registrations at 72 834 pieces. The Netherlands came next (66 957 pcs, + 146.3% y/y), France (61 356 pcs, +34.6% y/y) and Sweden (40 406 pcs, + 39.4% y/y). Registration results in Europe shows that the popularity of electric vehicles is increasing. Along with the development of this type of vehicles, the technology used in their construction also changes. The biggest calls at the moment are batteries for these vehicles, as well as their ranges on a single charge. There are already vehicles with ranges of 500 km or even 600 km. However, it turns out that these are not the only problems with electric vehicles One of the drawbacks is the way they heat their passenger cabins. There is no typical heater in an electric vehicle as in the case of a vehicle with a conventional drive. For this purpose, e.g. an electric heater with a blower is used for this purpose. For this reason, the authors of the paper decided to determine the efficiency of the heating system in an electric vehicle at low ambient temperatures. Own tests were carried out on the vehicle at temperatures of +5°C, −5°C and −10°C. Based on the research, the authors of the paper could draw conclusions on how to heat the interior in the electric vehicle under test, as well as check whether the efficiency of such a system for individual places in the car is sufficient to obtain the set temperature.