A 15-point Thomson scattering diagnostic system is developed for ENN’s spherical torus experiment XuanLong-50 (EXL-50). A BeamTech laser with 3 J/pulse (1064 nm wavelength) at 50 Hz repetition rate is chosen for measurements during EXL-50 plasma operations. To enable measurements at low density (∼0.5 × 1018 m−3) plasma operations, the opto-mechanical subsystems are carefully designed to maximize the collection and transmission of the scattered light and to minimize the stray light level. In addition, the high bandwidth trans-impedance amplifiers and segmented high speed waveform digitizers allow for the application of muti-pulse averaging to further improve the signal-to-noise ratio. Details of the diagnostic system are described and initial experimental results are presented.

Polychromators are most frequently used in Thomson scattering (TS) diagnostics to analyze the scattered light spectrum and intensity so that the plasma electron temperature (Te) and density (ne) can be derived. For Te measurements, the spectral response of the polychromator channels and the relative spectral responsivities need to be calibrated. The spectral response is calibrated with a bromine tungsten lamp and a monochromator in a conventional way. A novel method for calibrating the relative spectral responsivities of the polychromators is described in detail. A broadband pulsed Light Emission Diode (LED) is used, which has a spectral irradiance similar to that of the TS spectrum, and the LED can be driven in pulse mode with the pulse width similar to the TS signal pulse width of about 10–20 ns full width at half maximum. This new method allows for the calibration to be done after the polychromator is fully installed, and in situ system calibration can be easily performed, showing the advantages of accuracy, simplicity, efficiency, and flexibility. For ne measurements, absolute sensitivity calibration is done by Rayleigh scattering with argon gas. Formulas for calculating the plasma density from the calibration data and the polychromator signals from the off-laser wavelength channels are presented.

The Energy iNNovation’s XuanLong-50 is a spherical torus experiment with up to 10 s plasma operation duration. A 3 J/50 Hz pulsed laser is used in the Thomson scattering diagnostic system that is developed to measure the time evolutions of plasma electron temperature and density profiles. The expected laser pulse number is about 7.5 × 106/year with a power load of 150 W. To meet at least 1-year lifetime requirement, a Chevron type beam dump with polished molybdenum plates is designed and fabricated, which absorbs the laser beam energy in a 3D structure to reduce the laser fluence deposited on the material surface. To prevent the backscattered stray light from interfering with the Thomson scattering measurements, a 7.5 m beam path with folding mirrors is set between the beam dump and the plasma scattering volumes. Details of the beam dump design procedure including the laser beam profile control, multi-pulse laser damage threshold, heat dissipation, Zemax modeling, folding mirror selection, and beam path enclosure are presented together with the testing results.

No abstract