Perceptual sensitivity to a visual target presented in a random continuous sequence of targets and nontargets decreased rapidly over time when stimuli were highly degraded visually but not when moderately degraded or undegraded. Large declines in sensitivity, independent of changes in response criterion, were found after only 5 minutes of observation. These rapid decrements of sensitivity to degraded targets seem to result from demands on the limited capacity of visual attention.

Triangular voltage waveform was employed to distinguish the contributions of dielectric permittivity, electric conductivity and domain switching in current-electric field curves. At the same time, it is shown how those contributions can affect the shape of the electric displacement — electric field loops (D–E loops). The effects of frequency, temperature and microstructure (point defects, grain size and texture) on the ferroelectric properties of several ferroelectric compositions is reported, including: BaTiO 3; lead zirconate titanate (PZT); lead-free Na 0.5 K 0.5 NbO 3; perovskite-like layer structured A 2 B 2 O 7 with super high Curie point (T c ); Aurivillius phase ferroelectric Bi 3.15 Nd 0.5 Ti 3 O 12; and multiferroic Bi 0.89 La 0.05 Tb 0.06 FeO 3. This systematic study provides an instructive outline in the measurement of ferroelectric properties and the analysis and interpretation of experimental data.

In addition, it is of importance to note that a high power factor ( S 2 / ρ ) is also indispensable for a given TE material to maximize its output power. [ 3 ] Therefore, by taking account of the practical application, a simultaneously optimization in the electrical and thermal transport properties of TE materials is imperative to maximize the output power and conversion efficiency concurrently. Recently, some strategies have been proved to be effective and even high ZT values greater than 2.0 have been achieved in the Pb-based TE materials, [ 4,5 ] such as the band convergence, [ 6 ] electronic density of states (DOS) distortion, [ 7 ] carrier energy barrier fi ltering, [ 8 ] and the conduction (valence) band modifi cation [ 9 ] to enhance Seebeck coefficient for high power factor; while defect engineering, [ 10 ] nanostructuring, [ 11 ] and multiscale hierarchical architecturing [ 12 ] to enhance the scattering of phonons for low thermal conductivity. However, the environmentally hazardous Pb element prevents them from widespread application. Therefore, it is of signifi cance to develop eco-friendly TE materials for middle temperature application, such as Mg 2 Si, [ 13 ] Half-Heusler, [ 14 ] and BiCuSeO [ 15 ] based TE materials.More recently, chalcopyrite CuInTe 2 is being considered as a promising p-type TE material because of the merits of environmentally friendly chemical component, intrinsically high electrical conductivity, and high Seebeck coeffi cient owing to the degenerate energy bands near the valence band maximum (VBM). [ 16 ] Thus many efforts have been made theoretically and experimentally [17][18][19][20][21][22] to enhance its TE performance already, such as Cu defi ciency and cation substitution. However, since there are two cation sites (Cu and In) in CuInTe 2 , cation substitution often lacks specifi city and may generate both electron and hole simultaneously, making it diffi cult to enhance the electrical transport properties substantially. Besides, the less phonon scattering, mainly by point defects originated from chemical component regulation, rendering its thermal conductivity is still relatively high. It is well known that refi ning the microstructure into nanoscale is often effective in optimizing thermal transport properties, yet the electrical transport properties are usually deteriorated due to the inevitably scattering of carriers, as typical shown in the CuInTe 2 /graphene [ 23 ] and our

The authors present the structure transformation and magnetic properties of Bi1−xLaxFeO3 (x=0.0–0.15) ceramics prepared by a conventional solid-state reaction processing. Magnetic measurements reveal that remnant magnetization of 15% La-doped BiFeO3 has enhanced about 20 times as compared to pure BiFeO3. It is the structural phase transition (R3c–C222) near x=0.15 that destructs the spin cycloid, and thus enhances the ferromagnetic properties significantly. In these Bi1−xLaxFeO3 ceramic samples, besides the known antiferromagnetic Néel temperature TN1∼615K, another Néel temperature TN2∼260K can be observed due to the trace impurity phase of Bi2Fe4O9 in these ceramic samples.

We studied the effect of doping with Bi on the thermoelectric properties of SnTe-based materials.