Hybrid heterojunction devices are designed for ultrahigh response to NO2 toxic gas. The devices were constructed by assembling multi-walled carbon nanotubes (MWCNTs) on a microelectrode chip bridged bare Pt-electrode and a Pt-electrode with pre-grown SnO2 nanowires (NWs). All heterojunction devices were realized using different types of MWCNTs, which exhibit ultrahigh response to sub-ppm NO2 gas at 50 °C operated in the reverse bias mode. The response to 1 ppm NO2 gas reaches 11300, which is about 100 times higher than that of a back-to-back heterojunction device fabricated from SnO2 NWs and MWCNTs. In addition, the present device exhibits an ultralow detection limit of about 0.68 ppt. The modulation of trap-assisted tunneling current under reverse bias is the main gas-sensing mechanism. This principle device presents a concept for developing gas sensors made of a hybrid between semiconductor metal oxide NWs and CNTs.

No abstract

The air pollution caused by the emission of NO2 from vehicles in large cities is threatening human health. Thus, a highly sensitive gas sensor is required to monitor this gas. Here, we introduced the arc-discharge deposition of single-walled carbon nanotubes (SWCNTs) over SnO2 nanowires for highly sensitive NO2 gas sensors. The high-quality SnO2 nanowires were grown on-chip on interdigital Pt electrodes, whereas the SWCNTs were deposited by in situ arc-discharge method. To form the heterojunction between SnO2 nanowires and SWCNTs film, we controlled the length of the SnO2 nanowires to avoid bridging of the two electrode fingers while covering the entire surface of Pt electrodes. The SWCNTs were deposited through a shadow mask to ensure the contact between the SWCNTs and SnO2 nanowires but not the Pt electrodes. Electrical measurements confirmed the formation of non-linear contact between SnO2 nanowires and SWCNTs because of the n-p heterojunction. An increment in resistance (decrease in resistance) of the sensor was observed when measured in NO2 gas, indicating the good response characteristics of the device based on heterojunction between SnO2 nanowires and SWCNTs. In addition, gas-sensing measurement at different temperatures indicated that the fabricated sensor could detect low concentrations of NO2 gas in the range of 1–10 ppm, with response values of 20–80. The results demonstrated that the arc-discharge deposition of SWCNTs over SnO2 nanowires is effective for the fabrication of highly sensitive NO2 gas sensors.

No abstract